Sunrise Medical 500 SERIES, 600 SERIES instruction manual Articulating Legrest, Caster Plates

X . S E T U P & A D J U S T M E N T

X . S E T U P & A D J U S T M E N T

K. SWING-AWAY HANGERS & FOOTRESTS (60º OR 70º)

1.Installation

a.Place swing-away pivot saddle into the receiver on front frame tube with the footrest facing outward from the frame.

b.Rotate the footrest inward until it locks into place on locking bolt.

2.Removal

a.To remove footrest, push release latch toward the frame.

b.Rotate footrest outward and lift.

3.Height-Adjustment

a.Remove retaining bolt in the frame tube.

b.Slide footrest tubes up or down inside frame tube to desired height.

c.Align predrilled holes in footrest and reinsert bolts.

d.Tighten bolts.

4.Footplate Angle-Adjustment

a.Loosen the retaining bolt in the frame tube.

b.Reposition footplate to desired angle and re-tighten bolt.

Breezy 500

L. ARTICULATING LEGREST &	1
ELEVATING LEGREST (Optional)

1. Installation

a. Follow same steps as for swing-away hangers and footrests. (p. 40)

2.Adjustment

a.List legrest to chosen position. Legrest will lock in place.

b.To lower legrest, press release lever

(1) forward and lower legrest to chosen position. Legrest will lock in place.

M. CASTER PLATES

(not available on the 500)

Note: Use a torque setting of 50-65 in./lbs. (5.6-7.3 N.m) when adjusting caster angle.

1.Angle Adjustment

a.Loosen the two eccentric bolts that secure the caster assembly. Do not remove the clevis pin.

b.Place a large right triangle against the table surface and the front surface of the caster bearing housing.This will align the caster stem rotational axis perpendicular to the floor surface.

c.When alignment is satisfactory, retighten the two eccentric bolts.

d.Repeat the process for the other.

Breezy 510 & 600

930300 Rev. C 40 41 930300 Rev. C