Pride Mobility SC2700 owner manual C a R E a N D M a I N T E N a N C E

Page 39

X I . C A R E A N D M A I N T E N A N C E

Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your ability to perform the maintenance listed below, you may schedule inspection and maintenance at your authorized Pride Provider. The following areas require periodic inspection and/or care and maintenance.

TIRE PRESSURE

νIf equipped with pneumatic tires, always maintain a proper 30-35 psi tire pressure.

WARNING! It is important that 30-35 psi tire pressure be maintained in pneumatic tires at all times. Do not underinflate or overinflate your tires. Low pressure may result in loss of control, and overinflated tires may burst. Failure to maintain 30-35 psi tire pressure in pneumatic tires at all times may result in tire and/or wheel failure, causing serious personal injury and/or damage to your scooter.

νRegularly inspect your scooter’s tires for signs of wear.

EXTERIOR SURFACES

Bumpers, tires, and trim can benefit from an occasional application of rubber or vinyl conditioner.

WARNING! Do not use a rubber or vinyl conditioner on the scooter’s vinyl seat, flooboard, or tire tread. They will become dangerously slippery and result in personal injury and/or damage to your scooter.

BATTERY TERMINAL CONNECTIONS

νMake certain that the terminal connections remain tight and uncorroded.

νThe batteries must sit flat in the battery wells.

νThe battery terminals should face the rear of the scooter.

WIRING HARNESSES

νRegularly check all wiring connections.

νRegularly check all wiring insulation, including the charger power cord, for wear or damage.

νHave your authorized Pride Provider repair or replace any damaged connector, connection, or insula- tion that you find before using your scooter again.

ABS PLASTIC SHROUDS

νThe front tiller shroud, front shroud, and the rear shroud are formed from durable ABS plastic and are coated with an advanced formula urethane paint.

νA light application of car wax will help the shrouds retain their high gloss.

MOTOR BRUSHES

The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodi- cally for wear by your authorized Pride Provider.

AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY

You do not need to lubricate these items, as they are all prelubricated and sealed

Victory XL-4 /RevC/June03

www.pridemobility.com

39

Page 38 Page 40
Image 39
Page 38 Page 40
Contents Ultimate In Style & Performance F E T Y G U I D E L I N E S N T E N T S Information Exchange N T R O D U C T I O NPride Owners Club My Authorized Pride Provider IsQuick Reference Information Removable Parts Electromagnetic Fields S a F E T YGeneral ModificationsIncline Information PRE-RIDE Safety CheckWeight Limitations Tire InflationMaximum Recommended Incline Angle Braking Information Cornering InformationStreets and Roadways Stationary Obstacles STEPS, CURBS, ETC Outdoor Driving SurfacesInclement Weather Precautions Freewheel Mode Elevators Battery Disposal and RecyclingStairs and Escalators DoorsReaching and Bending Motor Vehicle TransportPositioning Belts Prescription DRUGS/PHYSICAL LimitationsAlcohol EMI/RFI Warnings EMI/RFI Frequently Asked Questions FaqsWhere do radio waves come from? I . E M I / R FWhat is the FDA doing about the problem? Are all electric mobility vehicles susceptible to EMI/RFI?What should I do if my mobility vehicle moves unexpectedly? Victory XL-4 Dimensions Specification SDimensions width 18 in. depth 18 in. usable Control Console Assembly Battery Condition MeterO U R V I C T O R Y X L Lower Front Headlight Switch Speed Adjustment DialKey Switch Running Lights SwitchFuse BOX Handbrake Lever OptionalRear Shroud Rear SectionBatteries Anti-tip Wheels Motor/Transaxle AssemblyElectronic Controller Module Manual Freewheel LeverFuses Not Shown Main Circuit Breaker Reset ButtonReading Your Battery Voltage B a T T E R I E S a N D C H a R G I N GCharging Your Batteries Can I use a different charger? Battery ReplacementFrequently Asked Questions Faqs How does the charger work?What type and size of battery should I use? How often must I charge the batteries?How can I get maximum range or distance per charge? Size Why do my new batteries seem weak?How can I ensure maximum battery life? TypeWhat about public transportation? How should I store my scooter and its batteries?Charger Fuse Getting Onto Your Scooter PRE-RIDE Adjustments and ChecksI . O P E R a T I O N Before Getting Onto Your ScooterRemove the key from the key switch Power Down Timer FeatureGetting OFF of Your Scooter I I . C O M F O R T a D J U S T M E N T S Tiller Angle AdjustmentSeatback Adjustment Seat Height AdjustmentFRONT-TO-BACK Seat Adjustment Seat Rotation AdjustmentPositioning Belt Optional Armrest AdjustmentPower Seat Actuator Power Seat OptionalD I S a S S E M B LY a N D a S S E M B LY Assembly Problem Possible Solutions TroubleshootingC a R E a N D M a I N T E N a N C E Storing Your Scooter FusesI . O P T I O N a L a C C E S S O R I E S Warranty Exclusions THREE-YEAR Limited WarrantyTHREE-YEAR Warranty Exceptions ONE-YEAR Limited WarrantySusquehannaAvenue Exeter, PA 18643
Top Page Image Contents