Before YOU Begin, Estimated Assembly and Set-Up Time

BEFORE YOU BEGIN

Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the scooter is 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.

MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR MAINTENANCE PROCEDURES.

Estimated Assembly and Set-Up Time

Allow up to 10 minutes for assembly, not including initial charge time.

Allow up to 12 hours for initial charge (see page 5 for charging information)

3.Charger

(Note: Charger design

may vary from one shown)

Twist Grip Throttle

Charger	Charger
Plug	Port End
	Port End

1. Handlebar

Stem

2. Battery Tray

WARNING:

DO NOT USE NON-RAZOR PARTS WITH YOUR RAZOR ELECTRIC SCOOTER. The scooter has been built to certain Razor design specifications. The original equipment supplied at the time of sale was selected on the basis of its compatibility with the frame, fork and all other parts. Certain aftermarket parts may or may not be compatible and will void your warranty.

PRODUCT I.D. CODE

1.Handlebar Stem

2.Battery Tray

3.Charger

4.UPC Side of Box (not shown)

Required Tools

5 mm Allen Wrench (Included)	8 mm/10 mm/16 mm	Phillips Screwdriver	Valve Extender	Bicycle-style tire pump
Two (2) 4 mm Allen Wrenches	Wrenches (Not Included)	(Only Included	(Located in right	for Schrader valve tires
(Only Included with E300S)		with E300S)	handlebar grip)	with pressure gauge
				(Not Included)

Need Help? Visit our website for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the product I.D. code (located on the white label on your product or back of charger) available for better assistance.