ASSEMBLY AND SET-UP
qAttaching the Seat (E300S Only)
Tools required: Two (2) 4 mm Allen wrenches and Phillips screwdriver.
1 Attach the seat to the seat | 2 Remove the four screws on | 3 Place the seat post on the |
post with two (2) 4 mm Allen | the middle of the deck with the | deck and secure using the same |
wrenches. See note below. | 4 mm Allen wrench and the | 4 screws. |
| Phillips screwdriver. |
|
Note: Do not completely tighten at this time. Adjust the seat tilt approximately level to the ground, or slightly tilted depending on your personal preference. Tighten securely. The seat tilt adjustment should not move when riding.
USAGE
qStarting the Scooter
To start unit, turn on power switch and twist throttle with both hands on the handlebar.
qStopping the Scooter
To stop unit, release the throttle and apply the brake until the unit comes to a complete stop. | Note: As an additional safety |
| feature, the scooter is designed |
| to cut power to the motor when |
| the hand brake is applied. |
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll free
4