BEFORE YOU BEGIN
Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the scooter was 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult with experience in bicycle mechanics.
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 3 for charging information)
3.Charger
(Note: Charger design may vary from one shown)
WARNING: DO NOT USE NON- RAZOR PARTS WITH YOUR RAZOR ELECTRIC SCOOTER.
The scooter has been built to certain Razor design specifications. The original equipment supplied at the time
of sale was selected on the basis of its compatibility with the frame, fork and all other parts. Certain aftermarket parts may not be compatible and will void the warranty.
Charger 
Charger
PlugPort
Twist Grip Throttle
Note: Electric scooter must be moving at 3 mph/4.8 kph while applying the throttle to engage motor.
1. 
2. Underneath
Battery Tray
Required Tools
Phillips
Product ID Locations:
See locations to the left
1.Handlebar Stem
2.Underneath Battery Tray
3.Charger
4.Box - Side of UPC (not shown)
3 mm 
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll free
2