REPAIR AND MAINTENANCE
Turn power switch “OFF” before conducting any maintenance procedures.
qAdjusting the Brakes
Tools required: 10 mm open wrench
1 To adjust brake cable play, thread the brake lever adjuster in or out 1/4 to 1/2 turn until the desired brake adjustment is attained. Most adjustments are complete at this step. If brake still needs further adjustment, proceed to step 2.
2If brake is too tight or has too much slack, use a 10 mm open wrench to loosen the brake cable and adjust accordingly.
3Inspect the brake pads (A) for proper alignment against the wheel or excess wear. To realign brake pads, loosen the fixing nut (B) and adjust the pad to contact the rim. Retighten and readjust as needed. Verify proper brake function prior to riding the scooter.
qFront Wheel Replacement
Tools required: 10 mm open wrench and two (2) 16 mm open wrenches.
1 Using a 10 mm open wrench | 2 Using two 16 mm open | 3 Reassemble, adjust and |
loosen the brake cable bolt. | wrenches, loosen the locknuts | tighten brake cable. Verify |
| by turning the wrenches counter | proper brake function prior to |
| clockwise. Remove wheel and | riding the scooter. |
| install replacement wheel. |
|
| Reference front wheel hardware |
|
| sequence on this page. |
|
qChain and Rear Wheel Replacement
Tools required: Phillips screwdriver and two (2) 13 mm open wrenches.
1 With a Phillips screwdriver, | 2 Using two 13 mm open | 3 To loosen the chain, pushing |
loosen the two screws and | wrenches, loosen the locknuts | the tensioner down to create |
remove the chain guard. | by turning the wrenches counter | some slack in the chain. |
| clockwise. Reference rear wheel |
|
| hardware sequence (page 6). |
|
Note: Front wheel hardware sequence
8-2
8-2
Right Side (Throttle)
Fork
Washer | |
Spring Washer | |
16 mm locknut |
Middle
Left Side (Brake)
Fork
Washer | |
Spring Washer | |
16 mm locknut |
5