Pride Mobility Jet2HD owner manual Battery Break-in, Frequently Asked Questions FAQs

Page 29

V I I I . B A T T E R I E S A N D C H A R G I N G

Battery Break-in

To break in new batteries for maximum efficiency:

1.Fully recharge any new battery prior to its initial use. This brings the battery up to about 90% of its peak performance level.

2.Operate your power chair throughout the house and yard. Move slowly at first, and do not travel too far until you become accustomed to the controls and break in the batteries.

3.Give the batteries another full charge of 8 to 14 hours and operate your power chair again. The batteries will now perform at over 90% of their potential.

4.After four or five charging cycles, the batteries will top off at 100% charge and last for an extended period.

Frequently Asked Questions (FAQs)

How does the charger work?

The battery charger takes the standard wall outlet voltage of 120 VAC (alternating current) and converts it to 24 VDC (direct current). The power chair batteries use direct current to run your power chair. When the battery voltage is low, the charger works harder to charge the battery. As the battery voltage approaches full charge, the charger doesn’t work as hard to complete the charging cycle. When the battery is fully charged, the amperage from the charger is nearly at zero. This is how the charger maintains a charge but does not overcharge the battery.

Can I use a different battery charger?

You should use the charger supplied with the power chair. It is the safest, most efficient tool to charge the batteries. We do not recommend using other types of chargers (e.g., an automotive battery charger).

NOTE: Your power chair’s charger will not operate after the batteries have been discharged to nearly zero voltage. If this happens, call your authorized Pride P=rovider for assistance.

How often must I charge the batteries?

Many factors come into play when deciding how often to charge the batteries. You may use your power chair all day on a daily basis or you may not use it for weeks at a time.

!Daily Use

If you use your power chair on a daily basis, charge the batteries as soon as you are finished. Your power chair will be ready each morning to give you a full day’s service. It is recommended that you charge the batteries 8 to 14 hours after daily use.

!Infrequent Use

If you use your power chair infrequently (once a week or less), you should charge the batteries at least once per week for 12 to 14 hours.

NOTE: Keep your batteries fully charged and avoid deeply discharging your batteries. Do not charge the batteries for more than 24 hours at a charging cycle.

Jet 2 HD

www.pridemobility.com

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Stylish Design and Premium Performance F E T Y G U I D E L I N E S III B L E O F C O N T E N T SN T R O D U C T I O N SafetyPURCHASER’S Agreement Information ExchangeMy Authorized Pride Provider Pride Owners ClubModifications Pre-Ride Safety CheckS a F E T Y Incline Information Weight LimitationsTire Inflation Public Streets and Roadways Braking InformationCornering Information Outdoor Driving Surfaces Freewheel ModeStationary Obstacles Steps, Curbs, etc Stairs and EscalatorsObject you are transferring onto TransfersDoors ElevatorsMotor Vehicle Transport Inclement Weather PrecautionsPositioning Belts Reaching and BendingElectromagnetic and Radio Frequency Interference EMI/RFI BatteriesAlcohol S a F E T Y JET 2 HD I . Y O U R P O W E R C H a I RSpecifications Electronics Tray Electronics TrayFreewheel Levers To engage or disengage the freewheel featureTo install the seat Seat InstallationController Installation To install the controllerSeat Height Adjustment Comfort AdjustmentsO M F O R T a D J U S T M E N T S To change the seat heightArmrest Height Adjustment Optional Armrest Width AdjustmentArmrest Angle Adjustment Controller Extension AdjustmentElevating Leg Rests Foot Platform Angle AdjustmentSwing-away Footrests To adjust the ELR length To adjust the ELR angleAnti-Tip Wheel Adjustment To adjust the anti-tip wheelsSeat Removal D I S a S S E M B L YTo remove the seat Body Shroud RemovalVSI Electronic Controller I . O P E R a T I O NVSI consists JoystickOn/Off Key Battery Condition MeterSystem OK Speed/Profile KeysHorn Key Controller ConnectorLocking/Unlocking the VSI Off-board Charger/Programming SocketThermal Rollback Charger Inhibit ConnectorVSI Error Codes I I . B a T T E R I E S a N D C H a R G I N G To charge the batteries using the onboard chargerBatteries and Charging Charging the BatteriesFrequently Asked Questions FAQs Battery Break-inWhy do my new batteries seem weak? What type of battery should I use?How can I ensure maximum battery life? How can I get maximum range or distance per charge?What about shipping? How should I store my power chair and its batteries?What about public transportation? Should your power chair come in contact with water Care and MaintenanceTemperature C a R E a N D M a I N T E N a N C EWeekly Checks Daily ChecksTo check the brakes Monthly ChecksYearly Checks Battery ReplacementTo replace the batteries StorageDrive Wheel Removal Cleaning Instructions Wheel ReplacementCorrective Maintenance When to See Your Authorized Pride Provider for ServiceA R R a N T Y Implied Warranties Service Checks and Warranty ServicePower Chairs
Top Page Image Contents