Pride Mobility 1103 ULTRA manual O M F O R T a D J U S T M E N T S, Comfort Adjustments

V . C O M F O R T A D J U S T M E N T S

COMFORT ADJUSTMENTS

After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to increase your comfort, such as seat height and angle, armrest angle, foot platform height and angle, and controller position.

NOTE: If your power chair is equipped with a Synergy Seat or TRU-Balance Power Positioning System, refer to the information provided in separate manuals. If your power chair is equipped with a contoured seating system or a power elevating seat, refer to the following information.

WARNING! If your power chair was configured by your authorized Pride Provider, please consult your healthcare professional before changing the seat position or making any other adjustment. Some adjustments may degrade your power chair’s performance and safety by changing its center of gravity.

WARNING! Some power chair components are heavy. You may need assistance to lift or carry them. Please refer to the specifications table for specific component weights before you disassemble the power chair.

WARNING! Remove the occupant from the power chair before making any adjustments.

You may need the following to make comfort adjust- ments:

!metric/standard socket set and ratchet

!adjustable wrench

!thread lock

Seat Height and Seat Angle Adjustment (Optional Trapeze Bar System)

You can change the seat height by raising the front and rear trapeze bars. If you raise or lower only one trapeze bar (front or rear), you can also change the seat base angle (dump).

To change the seat height:

1.Turn off the power to the controller.

2.Loosen the rear shroud fasteners and remove the rear shroud. See figure 6.

3.Disconnect the controller connectors from the power pod. See figure 7.

4.Flip up the seat latch safety. See figure 13.

5.Squeeze the seat latch and release the seat from the front trapeze bar.

6.Slide the seat forward and remove it from the power base.

7.Loosen the screws that attach the trapeze bars to the seat posts. See figure 14.

8.Remove the retaining clips that secure the seat posts to the power base. See figure 14.

9.Move the trapeze bars up or down to the desired height.

Figure 13. Seat Height Adjustment - Seat Latch Safety

SCREWS	SCREWS
	TRAPEZE BAR
TRAPEZE BAR
	SEAT POST
SEAT POSTS	RETAINING
	CLIPS
RETAINING
CLIPS

Figure 14.Trapeze Bar Location (Optional)

Jazzy 1103 Ultra www.pridemobility.com 25