Pride Mobility 1107 owner manual Foot Platform Angle Adjustment, Controller Position

Page 27

	V . C O M F O R T A D J U S T M E N T S
To clamp the quick release fastener:
1.	Make sure the lever is in the open position.
2.	Turn the nut clockwise until it is snug.
3.	Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed		SETSCREW
position, then turn the nut counterclockwise one-quar-
ter or one-half turn.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key.
See figure 21.
To adjust the foot platform angle:
1.	Flip up the foot platform and locate the setscrew.
2.	Turn the setscrew counterclockwise to raise the front of the
	foot platform.
3.	Turn the setscrew clockwise to lower the front of the foot

platform.

Figure 21. Underside of Foot Platform

Controller Position

You can position the controller for either left-hand or right- hand use.

WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.

To change the controller position:

1.Turnoffthepowertothecontroller.

2.Disconnect the controller from the power base.

3.Cut the wire tie(s) that attaches the controller cable to the armrest.

4.Flip up the armrest and loosen the setscrew. Seefigure22.

5.Slidethecontrolleroutofthearmrest.

6.Loosen the setscrew in the other armrest.

7.Placethecontrollerintheotherarmrest.

8.Tightenthesetscrewtosecurethecontroller.

9.Use a wire tie to secure the controller cable to the armrest.

10.Plug the controller into the power base. See figure 6.

SETSCREW

Figure 22. Underside of Armrest

SFR RELEASE LEVER

FOOTREST

EXTENSION

ADJUSTMENT

SCREWS

Figure 23. Swing-Away Footrests

Jazzy 1107

www.pridemobility.com

27

Image 27

Contents Exeter, PA St. Catharines, on F E T Y G U I D E L I N E S III N T E N T SInformation Exchange SafetyN T R O D U C T I O N PURCHASER’S AgreementMy Authorized Pride Provider Pride Owners ClubS a F E T Y Product Safety SymbolsS a F E T Y Modifications Pre-Ride Safety CheckWeight Limitations Tire InflationIncline Information Braking Information Cornering InformationOutdoor Driving Surfaces Doors Freewheel ModeStationary Obstacles Steps, Curbs, etc Public Streets and Roadways Stairs and EscalatorsMotor Vehicle Transport TransfersElevators Lift/Elevation ProductsReaching and Bending Inclement Weather PrecautionsPositioning Belts BatteriesElectromagnetic and Radio Frequency Interference EMI/RFI AlcoholJazzy I . Y O U R P O W E R C H a I RJazzy 1107 Power Base Electrical Components Jazzy 1107 SpecificationsJazzy 1107 Electrical Components Flight Controller Shown To engage or disengage the drive motors Manual Freewheel LeversA S S E M B L Y / D I S a S S E M B L Y Initial AssemblySeat Installation To install the seat initial installationTo remove the seat To disassemble the power base Power Base DisassemblyBattery Box Removal and Frame Separation To change the seat height Comfort AdjustmentsSeat Height and Seat Angle Adjustment O M F O R T a D J U S T M E N T SSeat Position Seatback Angle AdjustmentManual Recline Seatback Adjustment Armrest Width AdjustmentQuick Release Fasteners Armrest Angle AdjustmentFoot Platform Height Adjustment Foot Platform Depth AdjustmentController Position Foot Platform Angle AdjustmentSwing-away Footrests Elevating Leg RestsMulti-Axis Foot Plates To change foot plate angle D To adjust the anti-tip wheelsTo change foot plate position B To change foot plate tilt CB a T T E R I E S a N D C H a R G I N G Batteries and ChargingCharging the Batteries Frequently Asked Questions FAQs Battery Break-inInfrequent Use Why do my new batteries seem weak?How often must I charge the batteries? Daily UseWhat about shipping? How can I ensure maximum battery life?How should I store my power chair and its batteries? What about public transportation?Joystick I . O P E R a T I O NFlight Controller Flight consistsHorn Key Battery Condition MeterLock Mode On/Off KeySpeed Keys Sleep Mode If EnabledError Codes Error Code Probable Cause Possible SolutionVSI consists VSI Electronic ControllerSpeed/Profile Keys Red lights only lit or slow flash Charge batteries as soonLocking/Unlocking the VSI Actuator Connector OptionalController Connector Actuator Keys and Actuator Lights For Optional EquipmentThermal Rollback VSI Error CodesI I . C a R E a N D M a I N T E N a N C E Care and MaintenanceShould your power chair come in contact with water TemperatureMonthly Checks Daily ChecksWeekly Checks To check the brakesStorage Disposal of Your Power ChairCleaning and Disinfection Wheel ReplacementBattery Replacement I I . C a R E a N DTo replace the batteries Corrective Maintenance When to See Your Authorized Pride Provider for ServiceW a R R a N T Y Exclusions also include components with damage caused by Reconditioned Units WarrantyWarranty Exclusions Service Checks and Warranty ServiceT E S T E S T E S Pride keeps a more detailed report on file at the factory Quality Control