Pride Mobility owner manual Electrical Components, Jazzy 1107 Specifications

Page 17

I I I . Y O U R P O W E R C H A I R

JAZZY 1107 SPECIFICATIONS

Suspension:

Active Trac

Drive Wheels:

10 in., pneumatic, (10 in., solid are optional)

 

 

Caster Wheels:

6 in., solid, rear-mounted

 

 

Anti-tip Wheels:

5 in., solid, front-mounted

 

 

Maximum Speed:¹

Up to 4.5 mph

 

 

Brakes:

“Intelligent Braking” electronic regenerative, disc park brake

 

 

GroundClearance:²

2.5 in.

 

 

TurningRadius:²

21.875 in. (with foot platform)

 

 

Overall Size:²

Length: 40.25 in. (with foot platform)

 

Width: 23.375 in.

 

 

Seating Options:

Medium-Back Seat (standard)

 

Limited Recline High-Back Seat (optional)

 

Full Recline High-Back Seat (optional)

 

Specialty Seat (optional)

 

 

Drivetrain:

Two motor, mid-wheel drive

 

 

Range:¹

Up to 25miles

 

 

Batteries:³

Two 12-volt, U-1 batteries, 32AH

 

 

Battery Charger:

5-amp,off-board

 

 

Electronics:

60-ampPrideFLIGHTController

 

50-amp PG Drives VSI Controller

 

 

Weight Capacity:

300 lbs.

 

 

Component Weights:

Base: 98 lbs. (right section 40.5 lbs.; left section 40.5 lbs.; center section 17 lbs.)

 

Medium-Back Seat: 37 lbs. (average weight with armrests and universal mounting system extrusions)

 

Batteries: 29 lbs. each (battery boxes 4.5 lbs. each)

¹Varies with user weight, terrain type, battery amp hour rating (AH), battery charge, battery condition, and tire condition. ²Due to manufacturing tolerances and continued product improvement, this specification can be subject to variance of (+ or – ) 3%.

³AGM or Gel-Cell type recommended.

NOTE: All specifications subject to change without notice.

Electrical Components

The electrical components consist of the controller assembly, the batteries, and the motors. The batteries, motors, and controller power module are located on the power base assembly. See figures 6 and 7. The controller is located on the seat assembly. Connectivity between the controller and the motors, the batteries, and the battery charger is provided by one or more wiring harnesses.

Controller Harness Connector: The controller harness connector is where the controller plugs into the power base. Each controller uses a different type of harness. If the controller has a power module in the power base, the connector is a small communications-type connector. If the controller is integrated, then the harness has a large 9-pin connector. Regardless of which type of controller is used, the harness must be secured to the seat assembly and not allowed to drag on the floor.

Jazzy 1107

www.pridemobility.com

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Exeter, PA St. Catharines, on F E T Y G U I D E L I N E S III N T E N T SN T R O D U C T I O N SafetyPURCHASER’S Agreement Information ExchangeMy Authorized Pride Provider Pride Owners ClubS a F E T Y Product Safety SymbolsS a F E T Y Modifications Pre-Ride Safety CheckIncline Information Weight LimitationsTire Inflation Outdoor Driving Surfaces Braking InformationCornering Information Stationary Obstacles Steps, Curbs, etc Freewheel ModePublic Streets and Roadways Stairs and Escalators DoorsElevators TransfersLift/Elevation Products Motor Vehicle TransportPositioning Belts Inclement Weather PrecautionsBatteries Reaching and BendingElectromagnetic and Radio Frequency Interference EMI/RFI AlcoholJazzy I . Y O U R P O W E R C H a I RJazzy 1107 Power Base Electrical Components Jazzy 1107 SpecificationsJazzy 1107 Electrical Components Flight Controller Shown To engage or disengage the drive motors Manual Freewheel LeversA S S E M B L Y / D I S a S S E M B L Y Initial AssemblyTo remove the seat Seat InstallationTo install the seat initial installation To disassemble the power base Power Base DisassemblyBattery Box Removal and Frame Separation Seat Height and Seat Angle Adjustment Comfort AdjustmentsO M F O R T a D J U S T M E N T S To change the seat heightManual Recline Seatback Adjustment Seatback Angle AdjustmentArmrest Width Adjustment Seat PositionFoot Platform Height Adjustment Armrest Angle AdjustmentFoot Platform Depth Adjustment Quick Release FastenersController Position Foot Platform Angle AdjustmentMulti-Axis Foot Plates Swing-away FootrestsElevating Leg Rests To change foot plate position B To adjust the anti-tip wheelsTo change foot plate tilt C To change foot plate angle DCharging the Batteries B a T T E R I E S a N D C H a R G I N GBatteries and Charging Frequently Asked Questions FAQs Battery Break-inHow often must I charge the batteries? Why do my new batteries seem weak?Daily Use Infrequent UseHow should I store my power chair and its batteries? How can I ensure maximum battery life?What about public transportation? What about shipping?Flight Controller I . O P E R a T I O NFlight consists JoystickLock Mode Battery Condition MeterOn/Off Key Horn KeyError Codes Sleep Mode If EnabledError Code Probable Cause Possible Solution Speed KeysVSI consists VSI Electronic ControllerSpeed/Profile Keys Red lights only lit or slow flash Charge batteries as soonController Connector Actuator Connector OptionalActuator Keys and Actuator Lights For Optional Equipment Locking/Unlocking the VSIThermal Rollback VSI Error CodesShould your power chair come in contact with water Care and MaintenanceTemperature I I . C a R E a N D M a I N T E N a N C EWeekly Checks Daily ChecksTo check the brakes Monthly ChecksCleaning and Disinfection Disposal of Your Power ChairWheel Replacement StorageTo replace the batteries Battery ReplacementI I . C a R E a N D Corrective Maintenance When to See Your Authorized Pride Provider for ServiceW a R R a N T Y Warranty Exclusions Reconditioned Units WarrantyService Checks and Warranty Service Exclusions also include components with damage caused byT E S T E S T E S Pride keeps a more detailed report on file at the factory Quality Control
Top Page Image Contents