Pride Mobility Jet10Ultra manual When to See Your authorized Pride Provider for Service

Page 39

I X . C A R E A N D M A I N T E N A N C E

13.Removethebackbattery.

14.Placeanewbackbatteryonthebatterytray.Makesurethat

theterminalsarefacingforward.

15. Fastenthereusablestraparoundthebackbattery.

16.Connectthewiringharnessestothebackbattery.Seefigures 26 and 27.

WARNING! Prevent injury. Use only the

 

quick disconnect harness supplied with

 

the Jet 10 Ultra. It has a thermal fuse

 

on each lead.

Figure 27. Battery Wiring Diagram

17. Placeanewbatteryinthefrontofthebatterytray.Makesurethattheterminalsarefacingbackward.

WARNING! Prevent injury. Make sure you tighten the fasteners so that the connections are secure.

18.Fastenthereusablestraparoundthefrontbattery.

19.Connectthewiringharnessestothefrontbattery.Seefigures26and27.

20.Slidethebatterytraybackintothepowerbase.

NOTE: Make sure that the power pod is out of the way when reinstalling the batteries.

21.Reinstall the foot platform.

22.Reconnect the battery connector.

23.Reinstall the rear shroud and tighten the fasteners.

24.Charge the batteries. See VII. “Batteries and Charging.”

When to See Your authorized Pride Provider for Service

The following symptoms could indicate a serious problem with your power chair. If necessary, contact your authorized Pride Provider. When calling, have the model number, serial number, nature of the problem, and the error code if available.

νMotor noise

νCracked or broken connectors

νJerky motion

νBent or broken wheel assemblies

νPowers up, but does not move

νFrayed harnesses

νUneven wear on any of the tires

νPulling to one side

νDoes not power up

Corrective Maintenance

If the battery condition meter does not light up when you turn on the power:

νCheck the harness connections. Make sure they are tight.

νCheck the circuit breaker. Reset it if necessary.

νCheck the battery connections.

If the above conditions prove normal, you can load test the batteries with a battery load tester. These testers are available at automotive parts stores. Disconnect both batteries before load testing and follow the directions that come with the load tester. If either one of the batteries fails the load test, replace both of them. If your power chair still does not power up, contact your authorized Pride Provider.

Jet 10 Ultra/RevA/Apr04

www.pridemobility.com

39

Page 38 Page 40
Image 39
Page 38 Page 40
Contents Pride F E T Y G U I D E L I N E S N T E N T S N T R O D U C T I O N PURCHASER’S AgreementInformation Exchange Pride Owners Club S a F E T Y Product Safety SymbolsS a F E T Y Modifications Pre-Ride Safety CheckWeight Limitations Tire InflationIncline Information Cornering Information Braking InformationFreewheel Mode Outdoor Driving SurfacesStationary Obstacles Steps, Curbs, etc EMI & RFI Positioning Belts Inclement Weather PrecautionsRemovable Parts Reaching and BendingBatteries AlcoholElectromagnetic and Radio Frequency Interference EMI/RFI I . E M I / R FJet 10 Ultra T H E J E T 1 0 U L T R aJET 10 Ultra Specifications Jet 10 Ultra Power Base Jet 10 Ultra Electrical Components Electrical ComponentsTo engage or disengage the drive motors Manual Freewheel LeversSeat Installation To install the seatS S E M B L Y To change the seat height Comfort AdjustmentsSeat Height and Seat Angle Adjustment C O M F O R T a D J U S T M E N T SArmrest Width Adjustment Seatback Angle AdjustmentTo adjust the seatback angle To adjust the recline angleC O M F O R T Swing-away Footrests To adjust the SFR lengthController Position To change the controller positionTo rotate the ELRs To adjust the ELR angleTo adjust the ELR length To adjust the anti-tip wheelsBatteries and Charging TochargethebatteriesusingtheonboardchargerTochargethebatteriesusingtheoptionaloff-boardcharger I . B a T T E R I E S a N D C H a R G I N GHow often must I charge the batteries? Battery Break-inFrequently Asked Questions FAQs Howdoesthechargerwork? Can I use a different battery charger?Why do my new batteries seem weak? How can I get maximum range or distance per charge?What type of batteries should I use? What about shipping? How can I ensure maximum battery life?How should I store my power chair and its batteries? What about public transportation?Joystick I I . O P E R a T I O NVSI Controller VSI consistsAndelectricalsystemOK Battery Condition MeterKeypad On/Off KeyLocking/Unlocking the VSI Motor ConnectorsCharger Inhibit Connector Horn KeyBattery Connector VSI Error CodesThermal Rollback C a R E a N D M a I N T E N a N C E Care and MaintenanceShould your power chair come in contact with water TemperatureMonthly Checks Daily ChecksWeekly Checks To check the brakesStorage Cleaning Instructions Tire/Wheel ReplacementTo replace the batteries Battery ReplacementCorrective Maintenance When to See Your authorized Pride Provider for ServiceWarranty Exclusions FIVE-YEAR Limited WarrantyONE-YEAR Limited Warranty SIX-MONTH WarrantyImplied Warranties Service Checks and Warranty ServiceT E S T E S Model # Serial #
Top Page Image Contents