Pride Mobility Jet10Ultra manual Weight Limitations, Tire Inflation, Incline Information

Page 9

I I . S A F E T Y

NOTE: If you discover a problem, contact your authorized Pride Provider for assistance.

Weight Limitations

Your power chair is rated for a maximum weight capacity. Please refer to the specifications table for this limit.

WARNING! Exceeding the weight capacity voids your warranty and may result in personal injury and/or damage to your power chair. Pride will not be held responsible for injuries and/or property damage resulting from failure to observe weight limitations.

WARNING! Do not carry passengers on your power chair. Carrying passengers on your power chair may result in personal injury and/or property damage.

Tire Inflation

If your power chair is equipped with pneumatic tires, you should check or have the air pressure checked regularly. Proper inflation pressures will prolong the life of your tires and help ensure the smooth operation of your power chair.

WARNING! It is important that 35 psi tire pressure be maintained in pneumatic tires at all times. Do not underinflate or overinflate your tires. Low pressure may result in loss of control, and overinflated tires may burst. Failure to maintain 35 psi tire pressure in pneumatic tires at all times may result in tire and/or wheel failure, causing serious personal injury and/or damage to your power chair.

WARNING! Inflate your power chair drive tires from a regulated air source with an available pressure gauge. Inflating your tires from an unregulated air source could overinflate them, resulting in a burst tire and/or personal injury.

Incline Information

More and more buildings have ramps with specified degrees of inclination, designed for easy and safe access. Some ramps may have turning switchbacks (180-degree turns) that require you to have good cornering skills on your power chair.

νProceed with extreme caution as you approach the downgrade of a ramp or other incline.

νTake wide swings with your power chair’s front wheels around any tight corners. If you do that, the power chair’s rear wheels will follow a wide arc, not cut the corner short, and not bump into or get hung up on any railing corners.

νWhen driving down a ramp, keep the power chair’s speed adjustment set to the slowest speed setting to ensure a safely controlled descent. See VIII. “Operation.”

νAvoid sudden stops and starts.

When climbing an incline, try to keep your power chair moving. If you must stop, start up again slowly and then accelerate cautiously. When driving down an incline, set your power chair to the slowest setting and drive in the forward direction only. If your power chair starts to move down the incline faster than you anticipated or desired, allow it to come to a complete stop by releasing the joystick, then push the joystick forward slightly to ensure a safely controlled descent.

Jet 10 Ultra/RevA/Apr04

www.pridemobility.com

9

Image 9
Contents Pride F E T Y G U I D E L I N E S N T E N T S N T R O D U C T I O N PURCHASER’S AgreementInformation Exchange Pride Owners Club S a F E T Y Product Safety SymbolsS a F E T Y Modifications Pre-Ride Safety CheckWeight Limitations Tire InflationIncline Information Cornering Information Braking InformationFreewheel Mode Outdoor Driving SurfacesStationary Obstacles Steps, Curbs, etc EMI & RFI Positioning Belts Inclement Weather PrecautionsBatteries Reaching and BendingAlcohol Removable PartsElectromagnetic and Radio Frequency Interference EMI/RFI I . E M I / R FJet 10 Ultra T H E J E T 1 0 U L T R aJET 10 Ultra Specifications Jet 10 Ultra Power Base Jet 10 Ultra Electrical Components Electrical ComponentsTo engage or disengage the drive motors Manual Freewheel LeversSeat Installation To install the seatS S E M B L Y Seat Height and Seat Angle Adjustment Comfort AdjustmentsC O M F O R T a D J U S T M E N T S To change the seat heightTo adjust the seatback angle Seatback Angle AdjustmentTo adjust the recline angle Armrest Width AdjustmentC O M F O R T Controller Position To adjust the SFR lengthTo change the controller position Swing-away FootrestsTo adjust the ELR length To adjust the ELR angleTo adjust the anti-tip wheels To rotate the ELRsTochargethebatteriesusingtheoptionaloff-boardcharger TochargethebatteriesusingtheonboardchargerI . B a T T E R I E S a N D C H a R G I N G Batteries and ChargingFrequently Asked Questions FAQs Howdoesthechargerwork? Battery Break-inCan I use a different battery charger? How often must I charge the batteries?Why do my new batteries seem weak? How can I get maximum range or distance per charge?What type of batteries should I use? How should I store my power chair and its batteries? How can I ensure maximum battery life?What about public transportation? What about shipping?VSI Controller I I . O P E R a T I O NVSI consists JoystickKeypad Battery Condition MeterOn/Off Key AndelectricalsystemOKCharger Inhibit Connector Motor ConnectorsHorn Key Locking/Unlocking the VSIBattery Connector VSI Error CodesThermal Rollback Should your power chair come in contact with water Care and MaintenanceTemperature C a R E a N D M a I N T E N a N C EWeekly Checks Daily ChecksTo check the brakes Monthly ChecksStorage Cleaning Instructions Tire/Wheel ReplacementTo replace the batteries Battery ReplacementCorrective Maintenance When to See Your authorized Pride Provider for ServiceONE-YEAR Limited Warranty FIVE-YEAR Limited WarrantySIX-MONTH Warranty Warranty ExclusionsImplied Warranties Service Checks and Warranty ServiceT E S T E S Model # Serial #