V . C O M F O R T A D J U S T M E N T S
7.Loosen the setscrew in the other armrest.
8.Place the controller in the other armrest.
9.Tighten the setscrew to secure the controller.
10.Use a wire tie to secure the controller cable to the armrest.
11.Plug the controller connectors into the power pod. See figure 7.
12.Reinstall the rear shroud and tighten the fasteners.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key. See figure 17.
To adjust the foot platform angle:
1.Flip up the foot platform and locate the setscrew.
2.Turn the setscrew counterclockwise to raise the front of the foot plat form.
3.Turn the setscrew clockwise to lower the front of the foot platform.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to different heights in
To raise or lower the foot platform:
1.Remove the fasteners from the foot platform bracket. See figure 18.
2.Raise or lower the foot platform to the desired height.
3.Reinstall the fasteners into the foot platform bracket and tighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1.Remove the fasteners from the foot platform bracket.See figure 18.
2.Move the foot platform in or out to the desired depth.
3.Reinstall the fasteners into the foot platform bracket and tighten.
SETSCREW
Figure 17. Bottom View of Foot Platform
RELEASE FASTENERS |
FOOT PLATFORM |
RETAINING PIN |
FOOT PLATFORM BRACKET |
Swing-Away Footrests
To rotate the SFRs:
1.Push in the release lever. See figure 19.
2.Rotate the SFRs.
To adjust the SFR length:
1.Remove the two adjustment screws from the back of each footrest extension. See figure 19.
2.Slide the footrest up or down to the desired length.
3.Reinstall the two adjustment screws.
Figure 18. Foot Platform Adjustment
SFR RELEASE LEVER |
FOOTREST |
EXTENSION |
ADJUSTMENT |
SCREWS |
Figure 19. Swing-Away Footrests
Jet 3 Ultra | www.pridemobility.com | 25 |