Pride Mobility Jazzy 1122 owner manual Armrest Width, Armrest Angle, Armrest Height Optional

V I . C O M F O R T A D J U S T M E N T S

ARMREST WIDTH

To change the armrest width:

1.Locate the two adjustment knobs on the armrest receiver bracket. See figure 16.

2.Loosen the knobs.

3.Slide the armrests in or out, to the desired width.

4.Tighten the knobs.

ARMREST ANGLE

You can adjust the armrest angle to fit your specific needs.

JOYSTICK

MOUNTING

BRACKET

SETSCREW

To change the armrest angle:

1.Lift the armrest straight up so that it is perpendicular to the floor.

2.Use a 7/16-in. wrench to loosen the jam nut. See figure 17.

3.Use a 5/32-in. hex key to loosen the adjusting screw.

4.Turn the screw clockwise to lower the front of the armrest, or turn the screw counterclockwise to raise the front of the armrest.

5.Lock the adjusting screw into place by tightening the jam nut.

ARMREST HEIGHT (OPTIONAL)

Your Jazzy may be equipped with height-adjustable armrests.

To change the armrest height:

1.Loosen the setscrew located underneath the armrest using a 3/16- in. hex key.

2.Remove the ball detent pin from the armrest.

3.Move the armrest up or down to the desired height.

4.Align the holes and reinsert the ball detent pin.

5.Retighten the setscrew.

JOYSTICK EXTENSION

The joystick can easily slide out away from the armrest or in toward the armrest.

To extend the joystick :

1.Use a 3/16-in. hex key to loosen the setscrew. See figure 18.

2.Slide the joystick mounting bracket into or out of the armrest to the desired position.

3.Retighten the setscrew.

Figure 18. Joystick Extension

Figure 19. Swing-Away Joystick (Forward Position)

Figure 20. Swing-Away Joystick (Retracted Position)

JAZZY 1122/REV D/FEB 03 WWW.PRIDEMOBILITY.COM 25