Pride Mobility Mini Crosser A T T E R I E S a N D C H a R G I N G, Reading Your Battery Voltage

V . B A T T E R I E S A N D C H A R G I N G

Your PMV requires two long-lasting, 12-volt, deep-cycle batteries that are sealed and maintenance free. They are recharged by an off-board charging system.

!Charge your PMV’s batteries prior to using it for the first time.

!Keep the batteries fully charged to keep your PMV running smoothly.

READING YOUR BATTERY VOLTAGE

The battery condition meter on the tiller console indicates the approximate strength of your batteries using a color code. See figure 11. From right to left, green indicates fully charged batteries, yellow a draining charge, and red indicates that an immediate recharge is necessary.

NOTE: To ensure the highest accuracy, the battery condition meter should be checked while operating your PMV at full speed on a dry, level surface.

- +

Figure 11. Battery Condition Meter

CHARGING YOUR BATTERIES

PROHIBITED! Never use an extension cord to plug in your battery charger. Plug the charger directly into a properly wired standard electrical outlet.

PROHIBITED! Removal of the grounding prong can create an electrical hazard. If necessary, properly install an approved 3-pronged adapter to an electrical outlet having 2- pronged plug access. Failure to heed could result in personal injury and/or property damage.

WARNING! Ensure that both ends of the charger power cord are clean and dry before plugging the charger power cord into the off-board battery charger port or the electrical outlet.

Follow these easy steps to charge your batteries safely:

1.Position your PMV close to a standard electrical outlet.

2.Remove the key from the key switch.

3.Make certain that the manual freewheel lever is in the drive position.

4.Plug the charger power cord into the charger port on your PMV.

5.Plug the off-board charger into a standard electrical outlet and turn the charger on.

NOTE: We recommend that you charge the batteries for 8 to 14 hours.

6.When the batteries are fully charged, unplug the charger power cord from the electrical outlet and then from the charger port.

NOTE: There is a charger inhibit function on your PMV. The PMV will not run and the battery condi- tion meter will not operate while the batteries are charging.

20 www.pridemobility.com Mini Crosser