I I I . I N S T A L L A T I O N
Follow these steps to route the Power Tote
1.Route the lift system wiring harness (starting at the lift) through the interior of the vehicle until you reach the automobile battery. See figure 5. You will typically find pass through points at the rear lighting assemblies, which will enable you to route the cable through the trunk and under the back seat.
| LIFT FRAME |
GROUNDINGWIRE | WIRING HARNESS |
| |
VEHICLE BATTERY | LIFT WIRING CONNECTION |
Figure 5. Wiring Harness Installation
2.Conceal the harness behind or under the interior panels of the vehicle (there should be existing holes). Be certain that the harness is protected with a rubber grommet when passing it through the metal panels and into the engine compartment.
3.Inside the engine compartment, secure the harness to the firewall and the inner fender with plastic wire ties. Use care not to cause abrasions to the wiring harness. It is important to secure the wiring harness at various points along its run of the vehicle.
WARNING! Do not cut or shorten the wiring harness. If the harness is too long, coil the excess wire and secure it with plastic wire ties.
4.Connect the red wire to the positive (+) terminal and the black (grounding) wire to the negative
WARNING! Before operating the lift, inspect the wiring harness for proper routing and grounding. Improper routing can cause damage to the harness, and improper grounding can cause damage to the electrical system.
10 | www.pridemobility.com | Power Tote |