I . Installation | Pride Mobility P-100 specs

I I I . I N S T A L L A T I O N

POWER TOTE P-100 LIFT SYSTEM INSTALLATION

The Power Tote P-100 Lift System is designed to be easily installed onto any vehicle equipped with a Class 1, Class 2, or Class 3 hitch receiver. The hitch receiver should be installed no higher than 20 in. (50.8 cm) from the bottom of the hitch tube to the ground.

NOTE: Once installed, the lift system may obstruct the view of the vehicle license plate. Research the local laws for license plate obstruction in your area and install the optional license plate kit if necessary. Contact your authorized Pride Provider for more information.

WARNING! Prevent product and/or vehicle damage! The Power Tote P-100 Lift System should be installed by an authorized service technician only.

Follow these steps to install the Power Tote P-100 Lift:

1.Remove the pre-assembled mounting hardware from the Class 1 hitch bracket or Class 2 or Class 3 hitch tube and use it to attach the hitch bracket/hitch tube to the lift frame. See figure 1.

2.If your vehicle is equipped with a Class 1 hitch receiver, slide the hitch bracket over the hitch receiver, aligning the mounting holes. Secure the hitch bracket to the hitch re- ceiver with the supplied hardware. See figure 2.

3.If your vehicle is equipped with a Class 2 or Class 3 hitch receiver, slide the hitch tube into the vehicle hitch receiver, aligning the mounting hole closest to the lift with the mount- ing hole in the hitch receiver. See figure 3.

WARNING! Lifting weight beyond your physical capability can result in personal injury. Ask for assistance if necessary when attaching the lift frame to the hitch receiver.

WARNING! Avoid pinch points! Do not hold the lift frame by the pivot points when mounting the lift frame to the hitch receiver.

4.Secure the Class 2 or Class 3 hitch tube with the supplied bolt and nut, inserting the bolt from the passenger’s side through to the driver’s side of the hitch. See figure 3.

WARNING! Threading the bolt from the wrong side or allowing the bolt to turn while tightening the nut will dislodge the threaded insert in the hitch tube.

WARNING! Do not attach a Class 2 hitch tube to a Class 3 hitch receiver. Personal injury or product damage may result.

MOUNTING HARDWARE

HITCH BRACKET

LIFT FRAME

Figure 1. Hitch Tube Assembly (Class 1 Hitch Bracket Shown)

Figure 2. Lift Frame Vehicle Mounting (Class 1 Hitch Bracket Shown)

www.pridemobility.com

Power Tote P-100 Lift System