Pride Mobility P-100 manual Follow these steps to remove the wheelchair from the lift

I V . O P E R A T I O N

7.Loosen the securement knob on the rear of the lock-down arm and slide the arm down over the wheelchair armrests with enough pressure to hold the wheelchair in place. Tighten the securement knob to lock the arm in place. See figure 8.

WARNING! Ensure that the lock-down arm is adjusted so that it only applies the necessary amount of pressure needed to secure the wheelchair. Applying too much pressure to the wheelchair may result in product damage.

NOTE: You may need to raise and lower the lift plat- form a few times before achieving the proper amount of pressure needed for secure transport. Once the proper pressure is obtained, keep the lock-down arm set to this height for continued use.

NOTE: Pay attention to the path of the lift platform during operation. Make sure the lift does not rub against or interfere with the vehicle in any way. If you notice any contact between the lift platform and the vehicle, stop lift operation immediately and contact your authorized Pride Provider for assistance.

Follow these steps to remove the wheelchair from the lift:

1. Lower the platform to the ground.

2Unlock the wheelchair park brakes, and roll the wheel- chair off of the platform.

3.Pivot the platform to a vertical position, then raise the lift until the platform is secured in the stowed position by the locking bracket. See figure 9.

4.Remove the key from the lift system when it is not in use.

MANUAL POWER TOTE P-100 OPERATION

The lift system is equipped with a manual crank that serves as backup in the event of a power failure. Using the supplied tool, rotate the manual crank (located on top of the motor housing) clockwise or counterclockwise to move the plat- form up or down. See figure 9.

SECUREMENT KNOB

Figure 8. Lock-down Arm Positioning

MANUAL CRANK

LOCKING

BRACKET

Figure 9. Platform Storage

12 www.pridemobility.com Power Tote P-100 Lift System