Sunrise Medical S-646 SE instruction manual Check-Out, Battery Removal, SWING-AWAY Footrests

28	I X . S e t - u p , A d j u s t m e n t & U s e
C. CHECK-OUT
Be sure this chair performs to your chosen operational
settings. If it does not, turn the chair off immediately		A
and reprogram with the Quickie QTronix Programmer. if
you do not own a Quickie QTronix Programmer have
your supplier reprogram your wheelchair as needed. Or,
you can order a Quickie QTronix Programming Pad for
your own use, from your supplier.

NOTE– Repeat this procedure until the chair performs to your specifications

When properly set-up, this chair will operate		D
smoothly. Check to see that all components		C
work properly. If you detect a problem, be sure
to correct it before use.
D. BATTERY REMOVAL		A
To remove batteries for transport or service:
		B
1. Unlatch both the right and left battery box rear	A

I X . S e t - u p , A d j u s t m e n t & U s e			29
E. SWING-AWAY FOOTRESTS			E
1.	Installation		G
	a)	Place swing-away pivot pin (E) into the locat-
		ing hole (F) on top of the hanger mount with
		the footrest facing outward from frame.
	b)	Rotate the footrest inward until latch plate
		locks (G) into place on locking bolt.	F
2.	Removal		H
	a)	To remove footrest, press quick-release lever
		(H).
	b)	Rotate footrest outward and lift.

3.Height Adjustment

a)Loosen both bolts (A) in the hanger frame tube.

b)	Reposition footrest height.	A
c)	Re-tighten both bolts (A).
F. ELEVATING LEGREST (OPTIONAL)
1. Installation

To install or remove Elevating Legrest (ELR) see instruc- tions for Swing-away Footrest installation.

	cover retaining fasteners (A) by flipping back
	both latches and rotating one half turn.
2.	Lower battery box rear cover (B) until the cover
	is fully extended and supported by the cables
	(C).
3.	Disconnect the battery harness cables.
4.	Slide out batteries (D).
5.	Remove batteries (D).

Batteries may weigh up to 55 lbs. Care must be taken to avoid injury when lifting.

2.Adjustment

a)To raise legrest, lift to desired position. Legrest will automatically lock in place.

b)To lower legrest, while seated in chair, first lift slightly then press release lever (B) down and lower legrest to desired position.

G. REMOTE JOYSTICK INSTALLATION (OPTIONAL)

1.To Connect

a)Line up the small cylindrical connectors with each other.

b)Push together firmly.

2.To disconnect

Pull back on the retaining ring (A) of the lead cylindrical connector until it disconnects from the power cable.

B

A

930477 Rev. A 930477 Rev. A