To Fold & Unfold Chair, Wheel | Sunrise Medical Revolution manual

I X . C H A I R B A S I C S

B. TO FOLD & UNFOLD CHAIR

Note: You can remove quick-release wheels before you fold chair (and re-mount them before you unfold chair).

1.	To Fold Chair:
	a.	Move sure footrests are out of the way before you fold chair.
		(Swing-away, flip up or remove footrests.)
	b.	Remove cushion (if any).
	c. Grasp center of seat sling and lift sharply until chair folds.
2.	To Unfold Chair:
	a.	Stand to one side of chair. Check to make sure footrests do not interfere.
	b.	Tilt chair toward you far enough to take the weight off the opposite wheel.

X . S E T U P & A D J U S T M E N T

Note: Setting the wheelchair on a table or on a flat surface, such as a table or on a flat surface, such as a workbench, helps make these procedures easier.

	Note on Torque Setting: A torque setting is
	the optimum tightening which should be made
	on a particular fastener. A torque wrench
	which measures in./lbs. Should be used when	Quick-
	tightening fasteners on Quickie wheelchairs.	Quick-
	tightening fasteners on Quickie wheelchairs.	Release
	Unless otherwise noted, use a torque setting	Release
	Unless otherwise noted, use a torque setting	Button
	of 60 in./lbs.When setting up this wheelchair.	Button
	of 60 in./lbs.When setting up this wheelchair.

c. Push down on the seat rail closest to you until chair opens fully.

d. Make sure seat rail tubes snap into frame saddles.

A.WHEEL

Depress the quick-release button on the axle. Slide it into the axle sleeve until it locks.

B.SWING-AWAY ADJUSTABLE ARMRESTS (OPTIONAL)

1.Installation

a)Slide armrest into receiver on rear frame tube.

2.Swinging Away

a)Push armrest to the side and out of the way when transferring.

3.Removing Armrest

a)Pull armrest straight out of bracket.

C.HEIGHT-ADJUSTABLE ARMRESTS (OPTIONAL)

1.Installation

a)Slide the outer armpost into the receiver mounted to the wheelchair frame.

b)The armrest will automatically lock into place.

2.Height Adjustment

a)Rotate release lever to second stop.

b)Slide armrest pad up or down to desired height.

c)Return lever to locked position against armpost.

d)Push arm pad until upper armpost locks firmly into place.

3.Removing Armrest

a)Rotate release lever to first stop and remove the armrest.

Height-Adjustable

Armrest Key

1.Outer armpost

2.Standard receiver

3.Release lever

4.Armrest pad

5.Transfer bar

6.Side panel

7.Outer armpost tension adjustment set screws

8.Inner armpost

9.Receiver adjustment bolts

930354 Rev. B