X . S E T U P & A D J U S T M E N T
2.Inside or Outside Placement
a)Remove caster housing casters.
b)Remove the two eccentric bolts from
each caster.
c)Move
d)Move
e)Remount casters to caster bracket.
f)Tighten the eccentric bolts.
g)Replace caster housing covers.
K.FOOTREST
Use a torque of 100
adjusting footplate.
1. Height Adjustment
a) Remove bolts on both sides of footrest and loosen footplate.
b) Remove footrest tubes and slide plug up or down inside tube to correct position.
c)The end of the plug is tapped so a 3" - 1/4"x20 bolt (included with chair) may be used to help position the plug at the correct hole.
d)Align predrilled holes in footrest and reinsert bolts.Tighten.
2.Footplate Angle Adjustment
a)Loosen flathead screws.
b)Reposition footplate to desired angle and retighten screws.
L.WHEEL LOCKS
Quickie Revolution wheelchairs are shipped with one of two types of high- mount wheel locks.Wheel locks are installed at the factory unless you have requested otherwise.
Use a torque setting of 100
1. High-Mount Scissor Wheel Locks:
a) Loosen the screws on the top of each clamp.
b)Slide assembly toward rear wheel until clamp embeds into tire to prevent wheel movement, when in locked position.
c)Adjust angle position.
d)Tighten screws.
X . S E T U P & A D J U S T M E N T
M. ANTI-TIP TUBES (OPTIONAL)
Quickie Designs recommends
Use a torque setting of 100
1. Inserting Anti-TipTubes Into Receiver
a) Press the rear
b)Insert into the
c)Turn the
d)Insert second
2.Adjusting Anti-Tip Receiver
a)Remove
b)Remove button head bolt from
c)Reposition bracket to desired height.
d)Reinsert
e)Repeat with second
f)Press the rear
g)Insert it into the
h)Turn the
i)Insert second
3.Adjusting
a)Press the
b)Raise or lower to one of the three predrilled holes.
c)Release button.
d)Adjust the second
930354 Rev. B | 34 | 35 | 930354 Rev. B |
|
|