Sunrise Medical Quickie Match Point RAMPS, Slopes & Side Hills, Transfer, Curbs & Steps

Page 9

16

 

 

 

 

 

 

 

 

 

 

V

I

.

 

 

 

W

a

r

n

i

n

g

s

:

F

a

l

l

s

 

&

 

T

i

p

-

O

v e

r

s

 

G. RAMPS, SLOPES & SIDE HILLS

Riding on a slope, which includes a ramp or side hill, will change the center of balance of your chair. Your chair is less stable when it is at an angle. Anti-tip tubes may not prevent a fall or tip-over.

1.Do not use your chair on a slope steeper than 10%. (A 10% slope means: one foot in elevation for every ten feet of slope length.)

2.Always go as straight up and as straight down as you can. (Do not “cut the cor- ner” on a slope or ramp.)

3.Do not turn or change direction on a slope.

4.Always stay in the CENTER of the ramp. Make sure ramp is wide enough that you are not at risk that a wheel may fall over the edge.

5.Do not stop on a steep slope. If you stop, you may lose control of your chair.

6.NEVER use rear wheel locks to try to slow or stop your chair. This is likely to cause your chair to veer out of control.

7.Beware Of:

a.Wet or slippery surfaces.

b.A change in grade on a slope (or a lip, bump or depression). These may cause a fall or tip-over.

c.A drop-off at the bottom of a slope. A drop-off of as small as 3/4 inch can stop a front caster and cause the chair to tip forward.

8.To Reduce The Risk Of A Fall Or Tip-Over:

a.Lean or press your body UPHILL. This will help adjust for the change in the center of balance caused by the slope or side hill.

b.Keep pressure on the handrims to control your speed on a down slope. If you go too fast you may lose control.

c.Ask for help any time you are in doubt.

9.Ramps At Home & Work - For your safety, ramps at home and work must meet all legal requirements for your area. We recommend:

a.Width. At least four feet wide.

b.Guardrails. To reduce the risk of a fall, sides of ramp must have guardrails (or raised borders at least three inches high).

c.Slope. Not more than a 10% grade.

d.Surface. Flat and even, with a thin carpet or other non-skid material. (Make sure there is no lip, bump or depression.)

e.Bracing. Ramp must be STURDY. You may need bracing so ramp does not “bow” when you ride on it.

f.Avoid A Drop Off. You may need a section at the top or bottom to smooth out the transition.

If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of con- trol may occur and cause severe injury to the rider or others.

 

 

V

I

.

 

 

 

W

a

r

n

i

n

g

s

:

 

F

a l l s

 

&

 

T

i

p

-

O

v

e

r

s

 

 

 

 

 

 

 

 

 

 

17

 

 

H. TRANSFER

 

 

 

 

 

 

 

 

 

 

 

It is dangerous to transfer on your own. It requires good balance and agility. Be aware that there is a point during every transfer when the wheelchair seat is not below you. To Avoid A Fall:

1.Work with your health care advisor to learn safe methods.

a.Learn how to position your body and how to support yourself during a transfer.

b.Have someone help you until you know how to do a safe transfer on your own.

2.Lock the rear wheels before you transfer. This keeps the rear wheels from rolling. NOTE– This will NOT keep your chair from sliding away from you or tipping.

3.Make sure to keep pneumatic tires properly inflated. Low tire pressure may allow the rear wheel locks to slip.

4.Move your chair as close as you can to the seat you are transferring to. If possible, use a transfer board.

5.Rotate the front casters until they are as far forward as possible.

6.If you can, remove or swing footrests out of the way.

a.Make sure your feet do not catch in the space between the footrests.

b.Avoid putting weight on the footrests as this may cause the chair to tip.

7.Make sure armrests are out of the way and do not interfere.

8.Transfer as far back onto the seat surface as you can. This will reduce the risk that the chair will tip or move away from you.

If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of con- trol may occur and cause severe injury to the rider or others.

I. CURBS & STEPS

1.Each person who helps you should read and follow the warnings “For Safe Use” (Section VII).

2.Do not try to climb or descend a curb or step alone UNLESS you are a skilled rider of this chair and:

a.You can safely do a “wheelie”; and

b.You are sure you have the strength and balance to do so.

3.Unlock and rotate anti-tip tubes up, out of the way, so they do not interfere.

4.Do not try to climb a high curb or step (more than 4 inches high) UNLESS you have help. Doing so may cause your chair to exceed its balance point and tip over.

5.Go straight up and straight down a curb or step. If you climb or descend at an angle, a fall or tip-over is likely.

6.Be aware that the impact of dropping down from a curb or step can damage your chair or loosen fasteners.

If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of con- trol may occur and cause severe injury to the rider or others.

930469 Rev. A

930469 Rev. A

Image 9
Contents Quickie Match Point Sunrise Listens T r o d u c t i o nSunrise Medical For Answers to Your QuestionsGeneral Warnings T a b l e o f C o n t e n t sI c k i e M a t c h P o i n t E n e r a l W a r n i n g s Changes & Adjustments Safety ChecklistMotor Vehicle Safety Environmental ConditionsFor The Rider L sFor Attendants Center of BalanceObstacles WheeliesReaching or Leaning Moving BackwardRAMPS, Slopes & Side Hills TransferCurbs & Steps Escalators StairsLearning to do a Wheelie Descending a Curb or Single StepMaintenance Climbing StairsDescending Stairs I I R n i n g s C o m p o n e n t s & O p t i o n s QUICK-RELEASE Axles Modified Seat Systems C h a i r B a s i c sUpholstery Fabric To Mount & Remove Rear WheelsSET-UP E t u p & a d j u s t m e n tQUICK-RELEASE Axle Backrest Fixed or FoldingRear Axle Assembly Seat SlingCushion Optional Integral 5TH Wheel Caster ForksCHECK-OUT TroubleshootingI . M a i n t e n a n c e I I . M a i n t e n a n c eN r i s e M i t e d R r a n t y Sunrise Medical Mobility Products Division

Quickie Match Point specifications

The Sunrise Medical Quickie Match Point is a sophisticated wheelchair designed to meet the diverse needs of individuals seeking mobility solutions that prioritize both functionality and comfort. This innovative wheelchair stands out for its customized options, robust construction, and advanced technology, making it an ideal choice for users who demand both performance and personalization in their mobility devices.

One of the main features of the Quickie Match Point is its adjustable frame, which allows users to tailor the wheelchair's dimensions to their specific requirements. The frame is available in various widths and depths, ensuring an optimal fit that promotes posture and comfort. This customization is essential, as a proper fit can significantly enhance the user's overall experience and improve daily activities.

The Quickie Match Point also boasts a lightweight yet durable construction. The use of high-strength aluminum materials allows for a sturdy design that does not compromise on weight. This combination of durability and lightweight materials ensures that users can easily maneuver the chair while maintaining a strong, robust structure that can withstand everyday use.

Another notable feature is the wheelchair's seating system. The Quickie Match Point offers various seating options, including customizable cushions and backrests that provide excellent support and pressure relief. These seating options are pivotal in reducing the risk of pressure sores, allowing users to remain comfortable throughout the day.

The wheelchair incorporates advanced technologies that enhance its usability. For instance, the Quickie Match Point includes an innovative suspension system that absorbs shocks and provides a smoother ride, particularly on uneven terrains. This makes the wheelchair ideal for both indoor and outdoor use, ensuring a seamless transition across different environments.

Moreover, the Quickie Match Point is designed with an array of accessory options, enabling users to further personalize their wheelchair based on their lifestyle and needs. From custom wheel sizes to specialized handrims, the range of accessories ensures that each user can configure their wheelchair for maximum efficiency and comfort.

In summary, the Sunrise Medical Quickie Match Point is a versatile and adaptable mobility solution that combines advanced engineering with user-centric design. With its customizable frame, durable construction, advanced seating options, and innovative technologies, the Quickie Match Point stands as a premier choice for those seeking mobility solutions that do not compromise on comfort or performance.