Sunrise Medical Quickie S-525 Ramps AT Home & Work, Wheelchair Lifts, Curbs & Single Steps

Page 11

V I . ! G E N E R A L W A R N I N G S

U. RAMPS AT HOME & WORK

Make sure ramps meet all Building Codes for your area.

1.For your safety, have a licensed contractor build or remodel ramp to meet all standards.

2.Note: The proper design will vary, depending on such things as: the length and height of the ramp; the need for an intermediate platform; landing size; doors, and the direction of swing, and; whether the ramp includes a turn or angle.

At A Minimum:

1.Open sides of ramp must have side rails to prevent your chair from going over the edge.

2.Slope must not be steeper than one inch in height for every one foot of slope length.

3.Ramp surface must be even, and have a non-skid surface.

4.You may need to add a section at the top or bottom to avoid a lip or drop-off.

5.Ramp must be sturdy. Add bracing if needed, so ramp does not “bow” when you ride on it.

V. WHEELCHAIR LIFTS

Wheelchair lifts are used in vans, buses, and buildings to help you move from one level to another.

1.Always turn off all power to your chair when you are on a lift. If you fail to do so, you may touch the joystick by accident and cause your chair to drive off the platform. (Be aware that a “roll-stop” at the end of the platform may not prevent this).

2.Make sure there is not a lip or drop-off at the top or bottom of the platform. These may cause a fall or tip-over.When in doubt, have someone help you.

3.Always position the rider securely in the chair to help prevent falls while on a lift.

4.Avoid moving forward if a wheel is “hung up” on the lip of the ramp. Backup, reposition the caster for a more direct approach. And slowly try again.

V I .

G E N E R A L W A R N I N G S

!

W. CURBS & SINGLE STEPS

1.Your chair is not designed to drive up or down a curb or step more than two (2) inches high. Doing so may:

Result in a fall or tip-over.

Damage the frame, wheels, axles or other chair parts, or loosen fasteners.

2.To prevent a fall or tip-over, use wheelchair access ramps or have someone help you.

3.If you must climb or descend a curb or step alone do so at your own risk and use extreme care.

Go as straight up or straight down as you can. Never turn or climb or descend at an angle as a fall or tip-over is likely.

Proceed slowly, at a steady speed.

4.Make sure that persons who assist you review the “Tips For Attendants” and heed all warnings.

X.STAIRS

Never use this chair to go up or down stairs, even with an attendant. Doing so is likely to cause a fall or tip-over.

Y.ESCALATORS

Never take this chair on an escalator, even with an attendant. Doing so is likely to cause a fall or tip-over.

930486 Rev. A

20

21

930486 Rev. A

Image 11
Contents Quickie S-525 For Answers to Your Questions Sunrise ListensVII. Warnings Components & Options 111EMI Electromagnetic Interference Quickie S-525 Review this Manual Often Choose the Right Chair & Safety OptionsAdjust Chair to Your Ability What is EMI?Immunity Level Medium-Range Mobile TransceiversLong-Range Transceivers Distance from the SourceHelping the Rider Overcome AN Obstacle Weight LimitController Settings Safety CHECK-LISTEnvironmental Conditions Changes & AdjustmentsWhen Seated in a Parked Wheelchair Motor Vehicle SafetyDressing or Changing Clothes TransfersReaching or Leaning To Reduce the Risk of Injury AND/OR Damage to the ChairBeware ObstaclesDriving in Reverse RAMPS, Slopes & Side HillsStairs Ramps AT Home & WorkWheelchair Lifts Curbs & Single StepsBatteries ON/OFF SwitchANTI-TIP Levers ArmrestsSeating Systems Positioning Belts OptionalPush Handles Rear Wheel Locks OptionalTo Descend a Curb or Single Step To Climb a Curb or Single StepSWING-AWAY Footrests CHECK-OUT Battery RemovalTools YOU will Need Elevating Legrest Optional Remote Joystick Installation OptionTo Adjust the Height of the Remote Joystick DUAL-POST HEIGHT- Adjustable ArmrestsArmrest Angle Adjustment Contour High Back Contour Seats HEIGHT-ADJUSTABLE Armrests Optional Seat Frame onlyBackrest CHECK-OUT Seat Height and Angle AdjustmentParapak Seat Sling Seat Frame only Wheel LocksCircuit Breakers Performance Control SettingsQtronix Programming PAD Optional Thermal ROLL-BACKIntegral Joystick Remote Joystick Assembly OptionalIntroduction Battery ChargerCharging Batteries Connecting Batteries in Battery BOXAcid Burns Unsealed WET Cell Batteries Disposing of Batteries CleaningStorage Tips To Repair or Replace a Tire Battery MaintenanceOrdering Parts Maintenance Chart12 310 mm Drive Wheels Motor BrushesWiring Diagram Detail Remote Joystick What WE will do Additional WarrantyFor Life LimitationsSunrise Medical