Sunrise Medical Quickie S-525 Obstacles, Driving in Reverse, RAMPS, Slopes & Side Hills, Beware

Page 10

V I .

G E N E R A L W A R N I N G S

!

Q. OBSTACLES

Obstacles you may have to overcome in daily use include door thresholds, lifts, ramps and hazards such as potholes and broken pavement.These can damage your chair and may cause a fall, tip-over or loss of control.

1.Be aware that thresholds are very dangerous. (Even a small change in height may stop a caster wheel and cause your chair to tip). You may need to:

Remove or cover threshold strips between rooms.

Install a ramp at entry or exit doors.

2.Keep your eyes moving when you ride; scan the area well ahead of your chair.

3.Make sure the floor areas where you use this chair are level and free of obstacles.

4.To help correct your center of balance:

Lean your upper body forward slightly as you go up over an obstacle.

Press your upper body backward as you go down from a higher to a lower level.

R. DRIVING IN REVERSE

Use extra care when you drive your chair in reverse.You may lose control or fall if one of the rear wheels hits an object.

1.Operate your chair slowly and at an even speed.

2.Stop often and check to make sure your path is clear of obstacles.

S.RAMPS, SLOPES & SIDE HILLS

The center of balance of your chair changes when you are on a slope.

Note: “Slope” includes a ramp or side hill.Your chair is less stable when it is at an angle. Never use this chair on a slope unless your are sure it is safe.When in doubt,

have someone help you.

Beware Of:

1.Steep slopes. Do Not use this chair on a slope steeper than 10%. (A 10% slope means: One foot in elevation for every ten feet of slope length).

2.Wet or slippery surfaces (such as when ice, snow, water or oil film is present).A loss of traction may cause a fall or tip-over.

3.A change in grade on a slope (or a lip, bump or depression). These may cause a fall or tip-over.

4.A drop-off at the bottom of a slope. (A drop-off of as small as 3/4 inch can stop a front caster and cause the chair to tip forward).

V I .

G E N E R A L W A R N I N G S

!

T. TO REDUCE THE RISK OF A FALL,

TIP-OVER OR LOSS OF CONTROL:

1. Never use your chair on a slope unless you are sure you can do so without losing traction.

2.Always go as straight up and as straight down as you can.

Do not “cut the corner” on a slope

 

 

or ramp.

 

Do not turn or change direction

 

 

on a slope.

Fig. 1

 

 

3.Always stay in the center of the ramp. Make sure ramp is wide enough that you are not at risk that a wheel may roll off the side.

4.Lean or press your body uphill.This will help adjust for a change in the center of balance caused by the slope. (Fig. 1)

5.Keep your chair moving at a slow, steady speed. Keep control over the chair at all times.

On a descent, do not let your chair accelerate beyond its normal speed.

If the chair picks up speed, center the joystick to slow down or stop.

Note: The solid state controller of your chair has a logic system that will help control your speed when driving on a slope or up hill.

• If you stop, re-start slowly.

6.Never use rear wheel locks to try to slow or stop your chair.This is likely to cause the chair to veer out of control.

930486 Rev. A

18

19

930486 Rev. A

Image 10
Contents Quickie S-525 Sunrise Listens For Answers to Your QuestionsEMI Electromagnetic Interference 111VII. Warnings Components & Options Quickie S-525 What is EMI? Choose the Right Chair & Safety OptionsAdjust Chair to Your Ability Review this Manual OftenDistance from the Source Medium-Range Mobile TransceiversLong-Range Transceivers Immunity LevelSafety CHECK-LIST Weight LimitController Settings Helping the Rider Overcome AN ObstacleMotor Vehicle Safety Changes & AdjustmentsWhen Seated in a Parked Wheelchair Environmental ConditionsTo Reduce the Risk of Injury AND/OR Damage to the Chair TransfersReaching or Leaning Dressing or Changing ClothesRAMPS, Slopes & Side Hills ObstaclesDriving in Reverse BewareCurbs & Single Steps Ramps AT Home & WorkWheelchair Lifts StairsArmrests ON/OFF SwitchANTI-TIP Levers BatteriesRear Wheel Locks Optional Positioning Belts OptionalPush Handles Seating SystemsTo Climb a Curb or Single Step To Descend a Curb or Single StepTools YOU will Need CHECK-OUT Battery RemovalSWING-AWAY Footrests DUAL-POST HEIGHT- Adjustable Armrests Remote Joystick Installation OptionTo Adjust the Height of the Remote Joystick Elevating Legrest OptionalHEIGHT-ADJUSTABLE Armrests Optional Seat Frame only Armrest Angle Adjustment Contour High Back Contour SeatsBackrest Wheel Locks Seat Height and Angle AdjustmentParapak Seat Sling Seat Frame only CHECK-OUTThermal ROLL-BACK Performance Control SettingsQtronix Programming PAD Optional Circuit BreakersRemote Joystick Assembly Optional Integral JoystickBattery Charger IntroductionAcid Burns Unsealed WET Cell Batteries Connecting Batteries in Battery BOXCharging Batteries Storage Tips CleaningDisposing of Batteries Battery Maintenance To Repair or Replace a TireMotor Brushes Maintenance Chart12 310 mm Drive Wheels Ordering PartsWiring Diagram Detail Remote Joystick Limitations Additional WarrantyFor Life What WE will doSunrise Medical