LIFT THE SEAT
Frame
Slide Block
Groove
FIGURE 4 - REMOVING THE SEAT
6.Install the battery pack by grasping the handgrip and sliding the battery pack onto the charger con- nector on the frame (FIGURE 5).
êPUSH DOWN
TO INSTALL
Handgrip
REMOVING THE BATH LIFT FROM THE BATHTUB (FIGURE 8)
WARNING
Use proper lifting techniques to avoid in- jury. Keep back straight and bend knees when lifting components of the Bath Lift.
CAUTION
ALWAYS release suction cups from bathtub bottom BEFORE removing frame to prevent damage to the frame or bathtub.
1.Tilt the frame forward towards the drain or gently pull up on the suction cup loops to release the suction cups.
2.Remove frame from bathtub (FIGURE 8).
TILT FRAME
FrameFORWARDS
Battery Pack 
Frame
FIGURE 5 - INSTALLING THE BATTERY PACK
Suction Cup Loop
Suction Cup
Rubber Pad
Bathtub
NOTE: The battery pack should fit snugly and not wobble.
7.Lower the Bath Lift by pressing the DOWN (ê) button on the pendant (FIGURE 6).
Down
Pendant
FIGURE 6 - LOWERING THE BATH LIFT
NOTE: The lift will automatically stop at the top and bottom limits if UP/DOWN buttons are not released.
8.Remove the battery pack by grasping the handgrip on battery pack and pulling upwards (FIGURE 7).
PULL UP TO |
| handgrip |
REMOVE é |
| |
|
|
Frame
Battery Pack
FIGURE 7 - REMOVING THE BATTERY PACK
FIGURE 8 - REMOVING THE BATH LIFT FROM
THE BATHTUB
REPLACING SUCTION CUPS (FIGURES 9-12)
1.Lean Bath Lift backwards so that the back of the frame is resting on the floor.
WARNING
Always point the screwdriver away from your body. Otherwise injury may occur.
2.Place screwdriver behind the lip of the EXISTING end plug (FIGURE 9).
3.Use a hammer to gently tap the back of the screw- driver until the EXISTING end plug comes free.
Screwdriver
Base Frame
End Plug
NOTE: Suction Cup removed for clarity.
FIGURE 9 - REMOVING THE EXISTING END
PLUG
2