Invacare 1085143, RBL250, 1081003 Pull UP to é, Remove, Frame Battery Pack, Lower Seat, Seat Slide

WARNING

Lifting column MUST be in lowest position BEFORE installing frame to prevent tipping.

The frame should be placed into an EMPTY bathtub.

2.Remove the battery pack by grasping the handgrip on battery pack and pull upwards (FIGURE 17).

PULL UP TO é

REMOVE

Front of the Bathtub

Back of

(fixture end)

the

Bathtub

Suction Cup	Frame
	Rubber Pad

FIGURE 15 - INSTALLING THE BATH LIFT INTO

THE BATH TUB

Reinstall Seat onto Bath Lift Frame (FIGURES 16-18)

NOTE: If necessary, reinstall the battery pack on the frame.

1.Raise the bath lift all the way up by pressing the UP (é) button on the pendant (FIGURE 16).

NOTE: The lift will automatically stop at the top and bottom limits if UP/DOWN buttons are not released.

Pendant

Up

FIGURE 16 - RAISING THE BATH LIFT

Frame

Battery

Pack

FIGURE 17 - REMOVING THE BATTERY PACK

3.Lower the seat onto the frame, ensuring that the slide block on the back of the chair slides down the two (2) grooves on the frame (FIGURE 18).

NOTE: The seat MUST be lowered onto the frame until the spring loaded chair release button locks in place and an audible "click" is heard.

4.Position the Bath Lift in the bath tub, refer to POSI- TIONING THE BATH LIFT FRAME IN BATH TUB in this Instruction Sheet

LOWER

SEAT

Seat

Slide

Block

Frame

Groove

FIGURE 18 - INSTALLING THE SEAT

4