Installing Rear Leg Extension Options

NOTE: For this procedure, refer to FIGURE 2.

NOTE: Refer to Installation Warning on page 2.

1. Press the snap buttons to remove the two existing rear leg extensions from the walker.

NOTE: The rear leg extensions will not be reassembled to the walker when using the rear wheel attachments.

2.Press the snap button on the walker frame and install the new wheel attachment/leg extension onto rear leg of the walker.

3.Repeat STEP 2 for remaining rear leg.

4.Adjust the wheel attachment/leg extension to one of the adjustment holes.

5.Repeat STEP 4 for remaining wheel attachment/leg extension.

6.Ensure that the snap button of each leg fully protrudes through the desired adjustment hole and legs are adjusted so the walker sits level.

DETAIL “A” - MODEL NOS. 6264, 6264P, 6265, AND 6265P

Adjustment

HolesBrake

with

Wheel

NOTE: Brake with wheel is on same side of adjustment holes on model nos. 6264 and 6265.

DETAIL “B” - MODEL NOS.

6263 AND 6274

Adjustment

Holes

Sure Glide

DETAIL “C” - MODEL NO.

6266

Adjustment

Holes

FIGURE 2 Installing Rear Leg Extension Options

NOTE: For this procedure, refer to FIGURE 3 on page 5.

NOTE: Refer to Installation Warning on page 2.

1.Press the snap buttons on the walker frame to remove the rear leg extension from the walker.

2.Firmly grasp the leg extension and perform one of the following:

•Remove the existing glide tip from the leg extension.

•Remove the rubber tip from the leg extension.

Leg Extensions and	4	Part No 1118382
Wheeled Walker Accessories