Panasonic CZ-RD515U INSTALLATION INSTRUCTIONS Connection Kit, Parts included in the package, b

INSTALLATION INSTRUCTIONS

Connection Kit

Parts included in the package

See Table 1.

Table 1

Parts	Figure	Q'ty	Parts			Figure	Q'ty	Parts	Figure	Q'ty
				Truss-head Phillips
			Tapping	5/32		13/32"	1	Clamping		1
				(4	10mm)
			screw					strap
Wire
(with a		1							7-3/32"(180mm)
noise filter)
			Clamp				2	Wire tube		1
Installation			Label				1			Top cover
		1
instructions

Installing the connection kit

A.7000 BTU, 9000 BTU, and 12000 BTU inverter models

(1)Remove the air intake grille.

(2)Remove the terminal cover. Pull out the thermistor, then remove the grille.

‡For details on steps (1) and (2), refer to the Installation Instructions included in the outdoor unit package.

Tab Screw

Screw

(3)Disengage the top cover from the tabs on the sides of the component box, then pull the cover toward you to remove it. (Fig. 1)

(To disengage the tabs, pull the sides of the top cover sideways and out- ward from the component box.)

Component box

(4)Remove the 4 component box installation screws. (Fig. 1)

(5)Disconnect the indicator-side connec- tor (10P) of the wires that connect the indicator and component box (Fig. 2a). Then disconnect the connector on the component box side (10P) and remove the wires. (Lifting the P.C. board up slightly will make this work easier.) (Fig. 2b)

(6)After removing the wires, insert Connector 1 of the wires (Fig. 3a) that were included in the kit package into the indicator (Fig. 2a), then insert Connector 2 into the component box. (Fig. 2b)

At this time, pass the wires through so that they are held inside the 2 holders on the sides of the component box.

(Fig. 3b)

Connector (10P)

Indicator

Fig. 2a

Connector 3	Connector 2
	(10P)
(4P)
Noise filter

Connector 1

(10P)

Fig. 3a

Fig. 1

P.C. board

Connector (10P)

Fig. 2b

Holder

Fig. 3b

85264190590000 2011 CV6233187907