DRIVE ARM/SUPPORT BRACKET | PROCEDURE 4 |
INSTALLING/REMOVING DRIVE ARM ASSEMBLY TO/FROM TRANSMISSION (FIGURE 3)
Installing
1.Secure the drive arm assembly to the transmission lever and wheel lock support bracket with hex screw, two (2) fender washers, shifter spacer and hex nut. Tighten securely.
Removing
1.Remove the hex nut securing the hex screw to the transmission lever.
2.Remove the hex screw, fender washers and shifter spacer from the transmission lever.
Wheelchairs Built BEFORE 09/05/00
Wheelchair Wheel
Side Frame Lock
Support
Bracket
Fender | Hex Nut | |
Washers | ||
|
Hex Screw | Transmission |
| Lever |
Drive Arm
INSTALLING/REMOVING DRIVE ARM (FIGURE 4)
Installing
WHEELCHAIRS BUILT BEFORE 09/05/00.
1.Loosen, but DO NOT remove the drive arm release lever by rotating COUNTERCLOCKWISE.
2.Rotate the drive arm to align the flat surface on the drive arm with the drive arm release lever.
3.Insert the drive arm into the plunger extension tube.
4.Secure the drive arm to the plunger extension tube by turning the drive arm release lever CLOCKWISE. Tighten securely.
WHEELCHAIRS BUILT AFTER 09/05/00.
1.Remove the button screw located on the drive arm.
2.Align one (1) of the two (2) mounting holes in the plunger tube with the button screw mounting hole in the drive arm
3.Install the button screw into the drive arm and plunger tube mounting hole to secure the drive arm to the plunger tube. Tighten securely.
Removing
WHEELCHAIRS BUILT BEFORE 09/05/00.
1.Loosen, but DO NOT remove the drive arm release lever by rotating COUNTERCLOCKWISE.
2.Lift up on the drive arm to remove.
D R I V E
A R M
S U P P O R T
Assembly
Shifter
Spacer
Wheelchairs Built AFTER 09/05/00
Wheelchair Wheel
Side Frame Lock
Support
Bracket
Fender | Hex Nut |
Washers |
|
Hex
Screw
Transmission
Lever
Drive Arm | Shifter |
Assembly | Spacer |
FIGURE 3 - INSTALLING/REMOVING DRIVE ARM
ASSEMBLY TO/FROM TRANSMISSION
WHEELCHAIRS BUILT AFTER 09/05/00.
1.Remove the button screw located on the drive arm.
2.Lift up on the drive arm to remove.
B R A C K E T
13