Every Three 3 Months, Annually, F E T Y M M a R Y

S A F E T Y

S U M M A R Y

SAFETY SUMMARY/MAINTENANCE

SAFETY SUMMARY

NOTE: Refer to the 9000 Wheelchair Owner's Manual, Part Number 1056953 and Service Manual, Part Number 1076155 for additional safety information and overall maintenance requirements.

STABILITY WARNINGS

CLD installation may require changes to the current configuration of the wheelchair with respect to rear wheel and caster size. The back height, front caster size and/or position, seat-to-floor angle, position and/or size of the rear wheels, correct anti-tipper as well as the end user's disability or end user's physical condition and capabilities directly relate to the stability of the wheelchair. Any change to one

(1)or any combination of the ten (10) may cause the wheelchair to decrease in stability. These adjust- ments MUST be performed by a qualified technician.

Seat-to-floor heights have specific positions depending on rear wheel size, rear wheel position, front caster position and seat-to-floor angle. These adjustments MUST be performed by a qualified technician.

If changing the seat-to-floor height with or without changing the rear wheel size, the correct anti-tippers MUST be ordered to maintain a 1-1/2 to 2-inch ground clearance. Refer to the 9000 wheelchair owner's manual , part number 1056953.

INSTALLATION WARNINGS

CLD installation MUST be performed on the side of the wheelchair specified when ordered.

GENERAL WARNINGS

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

When installing the CLD onto 9000 wheelchairs with specific measurements, the wheelchairs MUST be equipped with the space saver arms. Refer to the chart on page 6 for specific measurements.

DO NOT operate the CLD on hills or inclines.

The weight limitation for the CLD is 250 lbs.

M A I N T E N A N C E

MAINTENANCE

EVERY THREE (3) MONTHS

Place a drop of oil on all linkage points (3-in-1 oil® or equivalent). Inspect and tighten bolts if loosened.

Clean chrome components with a soft cloth.

ANNUALLY

The CLD should be inspected by a qualified technician.

3-in-1 oil - Registered trademark of American Home Products Corporation.