Invacare 95-2, 95-1, 90-2 Assembling the Shower Chair, Installation Warning, Attaching the Legs

INSTALLATION WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching component parts are secure.

For Model Nos. 95-1, 95-2, and 90-2, ensure that the snap buttons fully pro- trude through the same respective adjustment hole of each adjustable leg before using. This ensures that the adjustable legs are securely locked in posi- tion and an even height adjustment is achieved.

ASSEMBLING THE SHOWER CHAIR

ATTACHING THE LEGS

NOTE: Refer to WARNINGS in the SAFETY SUMMARY of this instruction sheet.

NOTE: For this procedure, refer to FIGURE 1 and FIGURE 2.

1.Remove all contents from the package. For Model Nos. 95-1 and 95-2, put backrest to the side and refer to Installing/Removing the Backrest on page 4 after attaching and adjusting the legs.

2.Place seat upside down on a stable surface (floor, table, etc.).

3.Position one (1) leg over one (1) socket in the seat and align.

4.Angle the leg slightly so the rear corner enters the socket first as shown in FIGURE 1.

5.Push the leg down and rotate leg to front of socket until leg is fully seated in socket.

STEP 2

Leg

Seat

STEP 3

Leg

Socket

STEP 4	Leg
Rear
Corner	Socket

STEP 5

Leg

Front of

Socket

FIGURE 1 - ATTACHING THE

LEGS

CareGuard™Shower Chair 2 Part No 1118360