PREPARING THE INFINITY BACK FOR INSTALLATION | PROCEDURE 2 |
ADJUSTING THE MOUNTING HARDWARE (FIGURE 3)
NOTE: Refer to the INSTALLATION AND STABILITY WARNINGS in the SAFETY SUMMARY of this manual.
1.Hold the Infinity Back up to the back canes at the ap- proximate installation height.
2.Visually inspect each side of the Infinity Back to see if the width hardware is set at the appropriate height to match theclampinstallationand/orthebackcaneconfiguration.
3.Perform one (1) of the following:
CORRECT HEIGHT - Adjust the width of the width hardware. Refer to ADJUSTING THE MOUNTING HARDWARE WIDTH in this pro- cedure of the manual.
INCORRECT HEIGHT - Adjust the height of the width hardware. Refer to ADJUSTING THE MOUNTING HARDWARE HEIGHT in this pro- cedure of the manual.
Adjusting the Mounting Hardware Height
1.Remove the two (2) mounting screws from the width bracket.
2.Align the opening in the width bracket with either the UPPER or LOWER set of mounting holes.
3.Loosely install the two (2) mounting screws into the desired set of mounting holes as shown in FIGURE 3.
4.Adjust the width of the Infinity Back. Refer to ADJUST- ING THE MOUNTING HARDWARE WIDTH in this procedure of the manual.
Adjusting the Mounting Hardware Width
1.Hold the Infinity Back up to the back canes at the ap- proximate installation height.
CAUTION
There should be a gap no larger than
2.Visually inspect each side of the Infinity Back to see if the depth hardware touches the cane clamps on both back canes as shown in FIGURE 3.
3.Perform one (1) of the following: CORRECT WIDTH - Proceed to STEP 6. INCORRECT WIDTH - Proceed to STEP 4.
4.If necessary, loosen, but do not remove the two (2) mounting screws securing each upper width bracket to the back frame.
5.Slide the upper width brackets IN or OUT until the mounting pins fit flush into both upper (swivel) cane clamps and the depth hardware touches the cane clamps as shown in FIGURE 3.
6.Install the Infinity Back onto the wheelchair. Refer to INSTALLING/REMOVING THE INFINITY BACK in PROCEDURE 3 of this manual.
7.Torque the two (2) mounting screws on each of the four (4) width brackets to
Mounting Pin
Back
Cane
Depth 
Depth 
Hardware
Hardware
Mounting
Pin
UPPER (SWIVEL) | LOWER (FIXED) |
CANE CLAMP | CANE CLAMP |
SLIDE |
|
Width |
|
Bracket IN | UPPER |
or OUT | |
| Width |
| Bracket |
| Mounting Screws |
Mounting Pin
Depth
Hardware
UPPER |
| LOWER | |
Mounting | |||
Width | |||
Holes |
| ||
| Bracket | ||
|
| ||
NOTE: |
|
| |
Lower |
| Mounting | |
mounting |
| ||
| Screws | ||
pin not |
| ||
LOWER |
| ||
shown for |
| ||
Mounting |
| ||
clarity. |
| ||
Holes |
| ||
|
| ||
FIGURE 3 - ADJUSTING THE WIDTH
HARDWARE
P R E P A R I N G
T H E
B A C K
9