ResMed 60561 manual Reassembling your Swift LT, Reassembling the headgear

Page 7

Reassembling your Swift LT

1

Insert elbow into frame.

2

Align pillows with frame.

3

Push pillows ﬁrmly into frame. Ensure top and bottom retention tabs slot into place.

4

5

Check positioning markers on pillows and headgear are on the same side.

Slide left and right headgear stability arms onto frame. Ensure inner wall of pillows is in correct position.

If not, squeeze pillow sides to release inner walls.

Reassembling the headgear

A

B

Lay out the headgear as	(A) Thread the top straps
shown, writing facing	through the top buckle,
upwards.	then (B) back over to
	secure.

A

B

(A)Thread both backstraps through the back buckle (Velcro™ facing outwards), then (B) fold back over to secure.

6

Image 7

Contents Swift LT Intended Use Using the Swift LTParts of the Swift LT & Ordering Information Fitting your Swift LT Using Tube Retainer OptionalDisassembling your Swift LT Cleaning your Swift LT in the homeStorage Reprocessing your Swift LT between PatientsDisposal Reassembling the headgear Reassembling your Swift LTBefore using your Swift LT TroubleshootingSound Technical speciﬁcationsConsumer Warranty SymbolsManufacturer Distributed by EUR1-ENG