ResMed 628035 manual Removing your mask, Disassembly, Reassembly

Removing your mask

To remove your mask pull the mask and headgear by the fabric back strap up and over your head.

Disassembly

Refer to the disassembly illustrations in this user guide. A diagram showing the names of parts can be found in the Mask Components diagram near the beginning of this guide.

Disassembly steps

1.Remove the headgear by slightly twisting each headgear arm and pulling away from the node on the mask cushion.

2.Peel the mask cushion away from the swivel ring.

Note: The headgear straps are not intended to be disassembled and can be washed together.

Reassembly

Refer to the reassembly illustrations in this user guide. A diagram showing the names of parts can be found in the Mask Components diagram near the beginning of this guide.

Reassembly steps

1.Using your forefinger and thumb to stretch the inside of the mask cushion, insert the swivel ring into the mask cushion.

2.Allow the mask cushion to sit in the groove on the swivel ring. The mask cushion is correctly positioned when it is located in the swivel ring groove with no gaps. Ensure that the swivel ring is not pushed all the way into the mask cushion.

3.Rotate the elbow to ensure it moves freely in the swivel ring.

4.Thread the top strap through the top buckle with the notches facing up.

5.Hold the headgear arm with the opening facing you. Latch the headgear arm onto the node on the mask cushion. Make sure that the text on the headgear lines up with the text on the mask cushion.

4