Millennium Enterprises A1 service manual Pump Module Parts List, Qty Description

Pump Module Parts List

Item	Qty.	Description		Part No.
	1	Pump Module (complete), 12 Volt, Rear		917-A1516RNA
1	1	Pump Assembly (M268-0113) 12V-120G - Dual Relief / ARS (Includes Items 2 & 3)		31038-12V
2	1	Power Cable, Up Solenoid to Motor		29049
3	1	Solenoid, Up - 4-Post - Trombetta		31129
4	1	Diode Assembly, Up Solenoid		73906A
5	4	Nut, #10-32, Serrated Flange		83080
6	2	Fitting, Male 7/16-20 O-Ring to Male 7/16-20 JIC 37°		24504
7	1	Elbow, Female Swivel 7/16-20 JIC 37° to (2) Male 7/16-20 JIC 37°		26579
8	1	Switch, Pressure		31199
9	1	Control, Hand Pendant Assembly - Standard (Includes Items 10-18)		100063-001
10	1	Keypad, Hand Control		30000
11	1	Hand Pendant Case - Front		100027-001
12	1	Seal, Hand Control - Standard		100066-001
13	1	Module, Hand Control		100041-001
14	1	Screw, 10-32 x 1/2”, Phillip, Pan Head		82744
15	1	Hand Pendant Case - Rear		100028-001
16	1	Hanger, Round - Hand Control		73793
17	2	Screw, #4-40 x 1/4”, Phillip, Pan Head		11480
18	1	Cord, Coiled - 6-Conductor		100044-001
19	1	Shield, Electrical		31304
20	1	Control Board Assembly		100080-001
21	1	Plate, Backing / Mounting - Rear		985-0501RN
22	8	Standoff, Snap-In		31011
23	1	Cover, Pump, 2-Piece - Back (Complete Assembly 915-0513RNA Includes Items 23 - 30)		915-0513RN
24	1	Recepticle, Clip On		28803
25	1	Lens, Threshold Warning - Red		30704
26	1	Decal, Warning / Pressure Relief Valve (Not shown - see Decal Section)		22249
27	1	Spacer, Lens - NHTSA		31386
28	1	Metal Ring Base - Lamp		30971
29	1	Socket, Lamp		30703
30	3	Screw, #8-32 x 1/2” Pan Head Phillips - Thread Cut		30974
31	1	Bulb, Light		19841
32	1	Diode, Green LED, Panel Mount		29545
33	1	Strain Relief - Liquid Tight		30753
34	1	Rivet, Snap, .201” x .217”/.256”		25973
35	2	Washer, 5/16” Flat		10063
36	2	Bolt, 5/16-18 x 3/4”, Nylock, Hex	* See note below	29608
37	2	Bolt, 5/16-18 x 1/2”, Nylock, Hex	* See note below	10012
38	1	Cable, Ground		26161A
39	1	Washer, 5/16” External Tooth		16368
40	1	Beeper, Continuous		30487
41	1	Switch, Toggle		12185
42	1	Decal, Lift Power - On/Off (Not shown - see Decal Section)		21494
43	1	Stud, Power Feed		26084
44	1	Rubber Boot, Red tSee note below		82046
45	1	Harness, Interlock Interface		31077A
46	1	Pump Handle with Grip		17206A
47	1	Cover, Pump - 2-Piece - Top / Front (Complete Assembly 915-0519RNAIncludes Items 47 - 59)		915-0519RN
48	3	Rivet, Pop, SD43BS - 1/8” - .13”/.19”		12954
49	1	Plug, Window - Clear		30443
50	1	Stud, Wing Head - 1/4 Turn		28804
51	1	Retainer, Push On		28805
52	1	Washer, Nylon, 1/4” I.D. x 11/16” O.D. x .030”		12690
53	1	Clip, Pump Handle - Top		915-5517
54	1	Clip, Pump Handle - Bottom		915-5518
55	1	Decal, Manual Instructions - Public (Not shown - see Decal Section)		31412
56	1	Decal, Removal / Installaton - Pump Cover (Not shown - see Decal Section)		29051
57	1	Decal, Warning - Control Board Damage - ESD (Not shown - see Decal Section)		30787
58	1	Decal, Removal / Installation Pump Handle (Not shown - see Decal Section)		29052
59	1	Decal, Installation & Warning - Hydraulic Pressure Switch (Not shown - see Decal Section)		27154
60	1	Clamp, Hose - Solenoid Mounting		29663
61	1	Ground Wire, Motor		31263A
62	1	Solenoid, 4-Post		28308MOD

*Apply red #271 Thread Locker Loctite® to the four hex bolts (items 36 and 37) if a blue nylon patch is not present on

the bolts when retrofitting an M268-0113 pump assembly. Loctite® is available from The Braun Corporation under part number 11522.

tIndicates items available for replacement part purposes only. These items are not included with replacement pump modules.

Page 9