1.0 Introduction
The OMEGA® CL3512A calibrator/thermometer is two meters in one. The CL3512A simulates type J/K/T/E thermocouple signals. Each signal is adjustable by using the coarse and fine dials. The CL3512A can also be used as a dual type J/K/T/E thermocouple input thermometer. Features include a large 3½ digit display with backlighting and displa y selections of HOLD, °C/°F, and0.1/1°.
The source mode of the CL3512A simulates the thermocouple output to check the operation of a thermocouple meter and make rough calibration adjustments. A more accurate calibrator would be required for calibration of thermocouple meters to specify tolerances.
1.1 Safety Information
It is recommended that you read the safety and operation instructions before using the thermometer.
WARNING
To avoid electrical shock, do not use this instrument when working
voltages at the measurement surface over 24V AC or DC.
WARNING
To avoid damage or burns, do not make temperature measurement
in microwave ovens.
CAUTION
Repeated sharp flexing can break the thermocouple leads. To prolong lead life, avoid sharp bends in the leads, especially near the connector.
1
1.2 Unpacking
Remove the packing list and verify that all equipment has been received. If there are any questions about the shipment, please call the OMEGA Customer Service Department.
Upon receipt of shipment, inspect the container and equipment for any signs of damage. Immediately report any damage to the shipping agent.
NOTE
The carrier will not honor any claims unless all shipping material is saved for their examination. After examining and removing contents, save the packing material and carton in the event reshipment is necessary.
The following is supplied in the box:
CL3512A
Rubber boot
2 K beaded wire thermocouples
K calibration cable
9 volt battery
Operator's manual
2