LG Electronics QHW 6, QHW 30, QHW 15 manual Calibration, Linear calibrate

Page 17

SECTION 10 CALIBRATION

10.1 Linear calibrate

To start calibration turn the scale off and then turn it back on. Press the limit and % keys together during the initial counting from 9 to 0 on the display.

The display will show "unLoAd". Remove all weight from the pan and then press the ZERO/ENTER key to set the initial zero point.

The display will then show the first calibration weight request. Put this weight on the platform and then press the ZERO/ENTER key when stable. The scale should be stable before pressing the ZERO/ENTER key to accept a weight. The stability indicator will turn on to show the value is stable.

After all calibrate weight completed, press ZERO/ENTER to complete the calibration. The scale will begin counting back to zero after the last weight has been selected.

Calibration weights

QHW SERIES

Model #

QHW 3

QHW 6

QHW 15

QHW 30

Weight 1

zero

zero

zero

zero

Weight 2

1000g

2kg

5kg

10kg

Weight 3

3000g

6kg

15kg

30kg

10.2 Normal calibrate

To start calibration turn the scale off and then turn it back on. Press the Tare and % keys together during the initial counting from 9 to 0 on the display.

The display will show "unLoAd". Remove all weight from the pan and then press the ZERO/ENTER key to set the initial zero point.

Then use %, Limit and Tare key to key in calibrate weight, press Zero key to sure, display shows “load”, put this weight on platter, after stable indicator on, press Zero key to sure.

After selfchecking again, QHW is ready for you.

- 13 -

Image 17
Contents QHW series Page Contents Page Introduction QHW SpecificationsGeneral Installation InstallationZero or KEY DescriptionsDisplays TkglbZeroing the Display OperationParts Counting Manual Accumulation Accumulated TotalAutomatic Accumulation Battery Operation RS-232 Output Parameters Linear calibrate CalibrationZERO/ENTER Error Codes