A&D HL-300WP, HL-3000LWP, HL-3000WP, HL-1000WP manual Safety Precautions

Page 2

SAFETY PRECAUTIONS

All safety messages are identified by the following, “WARNING” or “CAUTION”, of ANSI Z535.4 (American National Standard Institute: Product Safety Signs and Labels). The meanings are as follows:

WARNING

A potentially hazardous situation which, if not

avoided, could result in death or serious injury.

 

CAUTION

A potentially hazardous situation which, if not

avoided, may result in minor or moderate injury.

 

‰This manual is subject to change without notice at any time to improve the product.

‰Product specifications are subject to change without any obligation on the part of the manufacture.

‰When using the HL-WP, the following safety precautions should always be followed.

WARNING Use only the specified AC adapter for the scale. Other adapters may cause damage (The AC adapter is optional).

Internal service or adjustments to this product should be performed by a qualified person.

CAUTION Avoid installing the scale in direct sunlight, which may cause discoloration or malfunctions.

Do not mix the type of batteries. Replace all the batteries at the same time.

If the scale is not to be used for a long period of time, remove all batteries from the battery compartment to avoid leakage.

Avoid overloading that could cause damage to the scale.

Avoid using the weighing pan to move the scale, as that could cause damage to the scale.

When the scale is used with an AC adapter, the scale does not conform to IP-65 protection.

IP65

Degree of protection against water: Protected against water jets.

Degree of protection against solid foreign objects: Dust-tight.

IP Code (Degree of protection provided by enclosures) of IEC 60529

1

Image 2
Contents Digital Scale Safety Precautions Parts Description 0120 00. k gInstalling Batteries / Connecting The AC adapter PreparationBefore weighing Weighing proceduresWeighing Calibration When to calibrateCalibration using a calibration weight Set the new value Gravity compensationSelect a digit to be changed Save the value in memorySpecifications ModelWorld Map