JVC manual Connecting the satellite speakers to the subwoofer TH-C90, Precautions for daily use

Connections

Do not connect the power cord until all other connections have been made.

7Connecting the satellite speakers to the subwoofer — TH-C90

Before connecting the speaker cords; Twist and pull the insulation coat off and remove.

Powered subwoofer

SP-PWC90

Front speakers

SP-THC90F

Center speaker

SP-THC90C

Speaker cord

•Connect the black striped cords to the black (r) terminals.

•Connect the clear cords to the (q) terminals referring to the table below:

FRONT SPEAKERS (LEFT)	White
FRONT SPEAKERS (RIGHT)	Red
CENTER SPEAKER	Green
SURROUND SPEAKERS (LEFT)	Blue
SURROUND SPEAKERS (RIGHT)	Gray

Surround speakers

SP-THC90S

CAUTION

•If you connect speakers other than the supplied ones, use speakers of the same speaker impedance (SPEAKER IMPEDANCE) indicated near the speaker terminals on the rear of the powered subwoofer.

•DO NOT connect more than one speaker to one speaker terminal.

•When installing the surround speakers on the wall;

–Be sure to have them installed on the wall by qualified personnel. DO NOT install the satellite speakers on the wall by yourself to avoid unexpected damage from falling off the wall due to incorrect installation or weakness in wall structure.

–Care must be taken in selecting a location for speaker installation on a wall. Injury to personnel or damage to equipment may result if the speakers installed interfere with daily activities.

Precautions for daily use

•When moving the speakers, do not pull the speaker cords; otherwise, the speakers may fall over, causing damage or injury.

•Do not reproduce sounds at so high a volume that the sound is distorted; otherwise, the speakers may be damaged by internal heat buildup.

•When holding a speaker, always grasp the lower portion.

•Do not lean against the speakers, as the speakers could fall down or break, possibly causing an injury. Especially be careful that children do not lean against them.

11