Basic operations
The buttons on the remote control are used to explain most of the operations in this manual. You can use the buttons on the center unit same as on the remote control for operations unless otherwise noted.
IMPORTANT
Before using the remote control for the following operation;
• Set the remote control mode selector to AUDIO.
The buttons described below are used on pages 15 to 17.
Source 
selecting 
buttons 
Remote control mode selector
Cursor (3/2)/ 
ENTER
STANDBY lamp
Turning the system on/off
On the remote control:
Press FAUDIO.
On the center unit:
Press F.
When DVD or USB MEMORY is selected as the source (see page 16), the following messages will appear on the TV screen.
•“OPEN”/“CLOSE”:
Appears when opening or closing the disc tray.
•“NOW READING”:
Appears when the system is reading the disc/file information.
•“REGION CODE ERROR!”:
Appears when the Region Code of the DVD VIDEO does not match the code the system supports. The disc cannot be played back.
•“NO DISC”:
Appears when no disc is loaded.
•“NO USB DEVICE”:
Appears when no USB mass storage class device is connected.
•“CANNOT PLAY THIS DISC”: Appears when unplayable disc is loaded.
•“CANNOT PLAY THIS DEVICE”:
Appears when unplayable USB mass storage class device is connected.
NOTE
•The STANDBY lamp on the center unit lights red when the power is turned off. The lamp goes off when the power is turned on.
•The power supply to the subwoofer is linked to the center unit. The POWER ON lamp on the subwoofer lights green when the power is turned on.
•A small amount of power is consumed even when the power is turned off (center unit only). This is called standby mode and the STANDBY lamp lights in this mode. Unplug the power cord from the AC outlet to turn the power off completely.
•You can also turn on the system by pressing the following buttons:
–One of the DISC
–One of the DISC
–One of the source selecting buttons or 3 on the remote control
–One of the DISC
15
