Chapter 3: SOHO 6 Basics

Firewall Settings

All incoming services are blocked.

An outgoing service allowing all outbound traffic. None of the Firewall Options are enabled.

The DMZ pass-through is disabled.

System Security

System Security is disabled and no System Administrator name or passphrase is set–the configuration pages are available to all on the trusted network.

SOHO 6 Remote Management is disabled. VPN Manager Access is disabled.

No remote logging is configured.

WebBlocker

WebBlocker is disabled and no settings are configured.

Upgrade Options

No upgrade options are enabled until the license keys are redeemed.

Reset a SOHO 6 to factory default

Firmware corruptions or other unforeseen events (such as a lost System Security passphrase) require you to reset the SOHO 6 to its factory default settings.

To do this, first disconnect the power supply. Then find the reset button located at the rear of the SOHO 6. Press and hold the reset button. At the same time, reconnect the power supply. Continue pressing the reset button while the SOHO 6 reboots– approximately 15 seconds. The PWR indicator light should blink in a steady pattern once the reboot is complete. When this occurs, reboot the SOHO 6 again by disconnecting the power supply.

26

WatchGuard Firebox SOHO 6.1

Page 44
Image 44
WatchGuard Technologies SOHO 6.1 Reset a Soho 6 to factory default, Firewall Settings, System Security, WebBlocker