Beko DV 6120 X manual Preparing laundry for drying, Correct load capacity, Loading

Page 8

Garments or pillows bolstered with rubber foam (latex foam), shower bonnets, water resistant textiles, materials with rubber reinforcement and rubber foam pads should not be dried in the dryer.

Do not use fabric softeners and anti-static products unless they are recommended by the manufacturers of the fabric softener or the product.

Do not dry the underwear reinforced with metal parts in the dryer. If these metal reinforcements loosen and break during drying, they will damage your dryer.

Preparing laundry for drying

Check all laundry items before loading them into the product to make sure that there are no lighters, coins, metal items, needles and etc. in their pockets or on any part of them.

Fabric softeners and similar products must be used in accordance with the instructions of the manufacturer of the relevant products.

All laundry must be spun at the highest spin speed that your washing machine allows for the laundry type.

Laundry may be tangled after washing.

Separate your laundry before placing them into your dryer.

Sort your laundry according to their types and thicknesses. Dry the same type of laundry together. E.g.: fine kitchen towels and table cloths dry faster than the thick bath towels.

Correct load capacity

AConsider the information in the “Programme Selection Table”. Always start the programme in accordance with the maximum load capacity.

CAdding laundry to the machine more than the level shown in the figure is not recommended. Drying performance will degrade when the machine is overloaded. Furthermore, your dryer and your laundry can be damaged.

CPlace your laundry into the drum loosely so that they will not get tangled.

CLarge pieces (E.g.: bed sheets, quilt covers, large tablecloths) may bunch-up. Stop the dryer 1-2 times during drying process to separate bunched-up laundry.

Following weights are given as examples.

Home articles

Approximate

weights (g)

 

 

 

Cotton quit covers (double)

1500

Cotton quit covers (single)

1000

Bed sheets (double)

500

Bed sheets (single)

350

Large tablecloths

700

Small tablecloths

250

Tea napkins

100

Bath towels

700

Hand towels

350

Garments

Approximate

weights (g)

 

Blouses

150

Cotton shirts

300

Shirts

200

Cotton dresses

500

Dresses

350

Jeans

700

Handkerchiefs (10 pieces)

100

T-Shirts

125

Loading

Open the loading door.

Place laundry items loosely into the dryer.

Push the loading door to close. Ensure that no items are caught in the door.

8 EN

Image 8
Contents Dryer DV 6120 Explanation of symbols Read this manual prior to initial operation of the productImportant safety information Never operate your dryer without the lint filter installedChildren’s safety Intended useInstallation Appropriate installation locationUnder counter installation Mounting over a washing machineAdjusting feet Electrical connectionFirst use Disposing of packaging materialInitial preparations for drying Things to be done for energy savingLaundry suitable for drying in the machine Laundry unsuitable for drying in the machineLoading Preparing laundry for dryingCorrect load capacity Control panel Filter cleaning warning light On/Off buttonSelecting a Program and Operating Your Machine Main programs Preparing the machine 1. Plug in your machineProgram selection Program selection and consumption table Program tableAdding/removing laundry in standby mode Auxiliary functionProgress of program Changing the program after the program has startedEnding the program through canceling End of programSensor models equipped with a sensor Maintenance and cleaningFilter Cartridge / Door Inner Surface Solution suggestions for problems