19510317700 English, All Logos to be Ariston | {PDF Created 18/01/13 22:04:00} |
Troubleshooting
One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the following troubleshooting suggestions.
GB
Problem: | Possible causes / Solutions: |
The dryer won’t start
Drying cycle will not begin.
It is taking a long time to dry.
Programme finishes and clothes damper than expected
•The plug is not plugged into the socket, or not making contact.
•There has been a power failure.
•The fuse has blown. Try to plug another appliance into the socket.
•You are using an extension cord. Try to plug the dryer’s power cord directly into the socket.
•The door is not closed securely.
•The PROGRAMMES knob has not been set properly (see Start and Programmes).
•The START/PAUSE button has not been pressed (see Start and Programmes).
•You have set a delay time (see Start and Programmes).
•The filter has not been cleaned (see Maintenance).
•The correct program has not been selected for the type of fabric you are drying (see Start and Programmes).
•The flexible vent tube is obstructed (see Installation).
•The air intake vent is obstructed (see Installation).
•The permanent Ventilation flap on the storm cover is obstructed (see Installation).
•The items are too wet (see Laundry).
•The dryer is overloaded (see Laundry).
!For safety the dryer has a maximum programme time of 4 hours. If an automatic programme has not sensed the required final moisture in this time the dryer will complete the programme and stop. Check the above points and run the programme again, if the results are still to damp, contact the service centre (see Service).
The option lights flash and the Display shows a fault code F followed by one or two numbers
The display briefly shows 
every 6 seconds.
•If the display shows a fault, Turn off and remove plug, Clean the Filter (see Maintenance). Then replace plug turn on and start another program. If a fault is then displayed. Note down the number and contact the service centre (see Service)
•The dryer is in ‘Demo’ mode. Press and hold both the On/Off and
Start/Pause buttons for 3 seconds. The display will show 
for 3 seconds and then the dryer will resume normal operation.
TD4241FUV Issue 1
16