Sharper Image GR-T200 instruction manual How to Use

How to Use
•	You can use the trimmer to trim nose and ear hair.
•	Test trimmer on a small area of your arm or
	leg. If any sensitivity occurs, discontinue using
	immediately. Do not use trimmer on sensitive or
	irritated skin.
•	Turn trimmer off before putting on or taking off
	attachments or cleaning.
Trimming Nose Hair
1.	Make sure nasal passages are clean
		Fig. 2
	before trimming.
2.	Remove the Protective Cap by pulling it
	off the trimmer (Fig. 2).
3.	Turn trimmer ON by pressing the
	On/Off POWER button (Fig. 3).
4.	Carefully insert the trimmer tip into one nostril.
	CAUTION: DO NOT insert the tip more
	than ¼” into nostril.
5.	Slowly move the trimmer tip in and out of each
	nostril to remove unwanted hair (Fig. 4).
6.	For best results, make sure the side of the tip is
	held firmly against the skin. This will reduce the	Fig. 3
	tickling effect that can occur.
7.	Clean trimmer immediately after using.
Trimming Ear Hair
1.	Clean outer area of ear and make sure it
	is free of wax.
2.	Remove the Protective Cap by pulling it
	off the trimmer.
3.	Turn the trimmer ON by pressing the
	On/Off POWER button.
	6	Fig. 4

4.Pull ear flat to head with one hand and hold trimmer with the other hand (Fig. 5).

5.Move trimmer tip around edges of ear to remove hairs extending beyond the outer ear. Carefully insert trimmer tip into outer ear no more than ¼”.

CAUTION: To avoid injury do not put any part of the trimmer into the ear. Do not insert the trimmer further than ¼” into the ear as this could cause damage to the eardrum.

6.Clean trimmer immediately after using.

Changing Trimmer Heads

There are two interchangeable blade heads. The rotary head is recommended to trim nose hairs, and the linear head is designed especially for ear and eyebrow hairs.

1.First, turn the trimmer OFF.

2.Detach trimmer head by tuning it counterclockwise to the unlocked position, then pull off.

3.Attach the other trimmer head by turning it clockwise into the locked position.

Cleaning Hair Reservoir

For easy cleaning, the nylon filter reservoir stores all the hair. This is possible by the powerful built-in vacuum.

1.First, turn the trimmer OFF.

2.Hold the trimmer upright for clean removal of hair reservoir.

3.Detach the nose head. Remove hair stored on the filter (Fig. 6).

7

Fig. 5

Fig. 6