When is it time to replace your heads and cutters?
It is very important to replace your heads and cutters when necessary to insure a close,comfortable shave without irrita- tion. We recommend they be replaced every 12 months.Here are some signs of head and cutter wear, indicating that replacement is needed.
Irritation:
As the heads get excessively worn there may be some skin irri- tation.This would be especially noticed when applying After Shave lotion.
When the cutters wear you may feel a sense of “pulling”and a loss of closeness when you shave.This is an indication that it is time to replace your heads and cutters.
Plastic Headguard
Brush
Trimmer
Button
Storage Pouch
Head & Cutter
Assembly
On/Off Button Locking Bar (Rechargeable Models only)
Charging
Indicator
(Green) All Models
except
Indicator (Red)
Shows When Shaver
Needs Charging
Battery Removal
(Corded/Cordless and Cordless Rechargeable Models Only)
When your rechargeable shaver reaches the end of its useful life,the batteries must be removed from
the shaver and be recycled or disposed of properly in accordance with your local and state requirements.
The following procedures should be followed for battery removal:
•Make sure your shaver is unplugged from any outlets,so you don’t risk an electrical shock.
•Remove the Head Assembly by gently lifting the assembly away from the shaver.
•Using a small Phillips head screwdriver, remove the screws from the upper and lower back
of the shaver.
•Pull or gently pry the the shaver halves apart, exposing the battery.
•Hold each battery in place and very carefully slide the clips from the terminals on each battery.
•Lift or pry the battery out of the shaver.
CAUTION:THESE
The EPA certified RBRC® Battery Recycling Seal on the