INSTALLATION
Speaker On/Off Switch
The speaker must be on during pro- gramming and recording the voice message in order to use the playback feature. For security purposes, the speaker may be turned off after pro- gramming to allow for silent dialing when the dialer is activated.
The On/Off switch for the speaker is located on the lower right corner of the circuit board. The default setting for the speaker is "On".
STANDARD PROGRAMMING
To program additional phone numbers, follow the above procedures by selecting a different phone number locations, from 1 to 9.
You may review a programmed phone number by following the same procedures as programming a phone number. Simply press [ ] when the display shows the current setting instead of entering a new value allows you to keep the programmed setting.
To erase a phone number from the Dial Alert, press [PROG] after step 3 above. That is after you select the phone number (from 1 - 9), Dial Alert will show the programmed phone number. Pressing [PROG] now will delete this phone number from the memory.
TESTING
To test the operation, you may activate dialer by pressing the red panic button [O] on the keypad of the
PROGRAM A CONTROL PANEL (MA-103)
You may use the Dial Alert to notify you when there is a
1.Enter the current password (factory default password is 0000), then press [PROG]. Display will show [P] meaning you are now in programming mode.
2.Enter [5] which represents programming a Control Panel. You will see [P5 Id codE].
3.Press and hold the “MUTE” button on the
4.After programming, the display will show ‘rEAdy” indicating it is now in standby mode.
INPUT DC 12V
MUTE | Mute |
| |
LEARN |
|
ALERT |
|
CHIME |
|
OFF |
|