Transformer Installation | Linear PERS-3600B guide

5. TRANSFORMER INSTALLATION

6. APPLY POWER - SELECT DIALING METHOD

1 PLUG TRANSFORMER INTO AN UN-SWITCHED AC OUTLET

2 SECURE TRANSFORMER WITH SCREW

7. TRANSMITTER INSTALLATION OPTIONS

FOR ALL TWO-BUTTON TRANSMITTERS

	WHEN IT IS	IT WILL
	WHEN IT IS	ACTIVATE
	INSTALLED	ACTIVATE
	INSTALLED	USING
	WITH THE	USING
	WITH THE	EITHER
	LEFT BUTTON	EITHER
	LEFT BUTTON	BUTTON
		BUTTON
	WHEN IT IS	IT WILL ONLY
	INSTALLED	ACTIVATE
	WITH THE	USING BOTH
	RIGHT BUTTON	BUTTONS

FOR DXS-31 STATIONARY TRANSMITTERS

WHEN IT IS INSTALLED	WHEN IT IS INSTALLED
WITH THE JUMPER SET	WITH THE JUMPER SET
FOR DELAY	FOR INSTANT
IT WILL	IT WILL
FUNCTION	FUNCTION
AS EMERGENCY	AS ACTIVITY

FOR MODEL DXS-32: CUT JUMPER (INSTANT TX) FOR USE

AS AN ACTIVITY TX. SEE DXS-32 INSTALLATION INSTRUCTIONS

SLIDE POWER

SWITCH ON

ON OFF

NOTE: THE DEFAULT DIALING METHOD IS TONE DIALING

IF REQUIRED, CHANGE THE DIALING METHOD BY PRESSING AND HOLDING THE HOME & CANCEL BUTTONS FOR 3 SECONDS WHILE SWITCHING THE POWER ON

• 7 BEEPS SOUND FOR PULSE DIALING

• 8 BEEPS SOUND FOR TONE DIALING

8. INSTALLING SINGLE TRANSMITTERS

ADDS ONE TRANSMITTER AT A TIME

1 PRESS CANCEL BUTTON FOR 5 SECONDS

• CONSOLE ANNOUNCES

THAT IT IS READY TO

LEARN TRANSMITTERS

2 ACTIVATE TRANSMITTER

• CONSOLE ANNOUNCES TRANSMITTER TYPE THEN REVERTS TO STANDBY MODE

NOTE: IF THE CONSOLE'S MEMORY

IS FULL, THE CONSOLE WILL ANNOUNCE "ERROR ZONES FULL"

DXS-62A

3REPEAT STEPS 1 & 2 FOR ADDITIONAL TRANSMITTERS (UP TO 16 TOTAL)

NOTE: PRESS CANCEL BEFORE TRANSMITTING TO RETURN TO STANDBY MODE WITHOUT ENTERING A TRANSMITTER

• THE CONSOLE WILL ANNOUNCE ITS STATUS

THE CONSOLE WILL RETURN TO STANDBY MODE AUTOMATICALLY WHEN A TRANSMITTER IS LEARNED OR AFTER 30 SECONDS HAS ELAPSED

NOTE: WRITE DOWN EACH TRANSMITTER'S TYPE AND ZONE NUMBER WHEN THE TRANSMITTER IS ADDED. THE CENTRAL STATION WILL NEED TO KNOW THE TYPE AND REPORTING ZONE FOR EACH TRANSMITTER.