Local Programming with RA-2400, Audio Operation

13. LOCAL PROGRAMMING WITH RA-2400

1PERFORM THE STEPS DETAILED IN THE

RA-2400/PERS REFERENCE GUIDE (P/N 224756)

TO SET UP THE RA-2400 PROGRAM

2 TO LOCALLY PROGRAM THE CONSOLE, CONNECT THE MODEM'S LINE JACK TO THE CONSOLE'S LINE JACK

LINE-TO-LINE

3PRESS THE TEST BUTTON MOMENTARILY

• CONSOLE ANNOUNCES TEST MODE

• START A LOCAL CONNECTION WITH THE RA-2400 SOFTWARE

NOTE: CONSOLE WILL EXIT TEST MODE

AUTOMATICALLY AFTER 3 MINUTES

14. SYSTEM OPERATION

	CONSOLE	HOME LIGHT SHOWS
	STANDING BY	ACTIVITY TIMER STATUS
	POWER	THE OTHER
	POWER	CONSOLE
	LIGHT	CONSOLE
	LIGHT	LIGHTS ARE
	IS ON	LIGHTS ARE
	IS ON	NORMALLY
		NORMALLY
		OFF

- IN CASE OF EMERGENCY -

PRESS AND

MOMENTARILY

HOLD THE

HELP BUTTON - OR -

ACTIVATE

AN EMERGENCY

TRANSMITTER

OR BY PRESSING THE CANCEL BUTTON

4WHEN RA-2400 CONNECTION TIMER

STARTS COUNTING DOWN,

PRESS THE HELP BUTTON

• THE CONSOLE ANNOUNCES "PHONE ON" WHEN THE CONSOLE HAS CONNECTED

5PERFORM PROGRAMMING IN THE RA-2400 SOFTWARE, SEND AND SAVE THE ACCOUNT PROFILE, THEN DISCONNECT FROM THE CONSOLE

CONSOLE

IN ALARM

THE CONSOLE ANNOUNCES EMERGENCY UNTIL THE CANCEL BUTTON IS PRESSED,

CENTRAL STATION REPORT IS COMPLETE,

OR THE SIREN TIME EXPIRES

PRESS TRANSMITTER BUTTON FOR AT LEAST 2 SECONDS

SENDING LIGHT

FLASHES DURING

COMMUNICATION

PRESS CANCEL TO STOP THE ALARM (ADDS CANCEL TO ALARM REPORT IN PROGRESS)

15. ACTIVITY TIMER OPERATION

1 ENABLING THE ACTIVITY TIMER

PRESS THE HOME BUTTON FOR 5 SECONDS TO TURN THE ACTIVITY TIMER ON

NOTE: THE ACTIVITY TIMER CAN BE ENABLED FOR 8, 12, OR

24 HOURS, OR DISABLED BY PROGRAMMING

NOTE: TO TURN THE ACTIVITY TIMER OFF, PRESS THE HOME BUTTON FOR FIVE SECONDS, THIS WILL ALSO TURN ON/OFF REMINDER REPORTING IF REMINDER SCHEDULE TIME OUT REPORT IS ENABLED IN THE RA-2400 SOFTWARE (ACTIVITY TIMER CAN BE DISABLED SEPARATELY IN RA-2400 ALARMS PROGRAMMING)

16. AUDIO OPERATION

1PROGRAM THE CONSOLE FOR THE DESIRED AUDIO MODE:

1)LISTEN-ONLY

2)2-WAY MANUAL

3) 2-WAY VOICE ACTIVATED (DUPLEX)

2AFTER THE CENTRAL STATION OPERATOR ACKNOWLEDGES THE COMMUNICATOR'S REPORT, THE CONSOLE WILL STOP ITS LOCAL ALARM AND SWITCH TO THE SELECTED AUDIO MODE FOR 90 SECONDS

AUDIO OPERATION CAN ALSO BE ESTABLISHED BY CALLING THE CONSOLE TWICE AND KEYING IN THE FOUR DIGIT REMOTE AUDIO PASSWORD FOLLOWED BY THE # KEY (SEE SECTION #22)

3 CENTRAL STATION OPERATOR OR AUDIO CALLER:

USE THESE KEYS ON A TELEPHONE SET TO CONTROL THE CONSOLE'S

2ACTIVITY TIMER RUNNING

THE HOME INDICATOR WILL LIGHT, SHOWING THAT THE ACTIVITY TIMER IS ENABLED

4RESETTING ACTIVITY TIMER

THE SUBSCRIBER NEEDS TO PRESS THE HOME BUTTON OR TRIGGER AN ACTIVITY TRANSMITTER BEFORE THE TIMER EXPIRES TO PREVENT AN INACTIVITY REPORT

PRESSING THE HOME BUTTON RESTARTS THE TIMER

3TIME RUNNING OUT

THE HOME INDICATOR WILL BLINK & THE CONSOLE ANNOUNCES EVERY 10 SECONDS WHEN LESS THAN

15 MINUTES OF TIME REMAIN

AUDIO MODE (IN CENTRAL STATION, CONNECT A TELEPHONE TO THE

SAME TELEPHONE LINE AS THE CENTRAL STATION RECEIVER)

ALL		PRESS "9" TO

AUDIO
		DISCONNECT THE CALL
MODES

2-WAY		PRESS "3" TO LISTEN
2-WAY

MANUAL
AUDIO
MODE	PRESS "1" TO TALK
	PRESS "1" TO TALK

THE "1" AND "3" KEYS ARE NOT USED IN LISTEN-ONLY AUDIO MODE

THE "1" AND "3" KEYS CAN BE USED IN 2-WAY VOICE ACTIVATED MODE. USING THEM WILL CAUSE THE SYSTEM TO SWITCH TO 2-WAY MANUAL MODE. PRESSING "8" RESTORES 2-WAY VOICE ACTIVATED MODE.

PRESSING ANY KEY OTHER THAN "9" WILL EXTEND THE AUDIO TIME 90 MORE SECONDS