Operating Instructions

Preparation Before Lifting

1.Turn on the power by twisting the RED RESET BUTTON clockwise.

2.Press the UP or DOWN button on the hand control once. Check if the battery indicator lights are on. To proceed with lifting, make sure there is at least one green light. Batteries are fully charged when three (3) green lights are shown.

3.After the battery indicator lights go out, push the UP button and the DOWN button on the hand control and ensure that the lift is operating correctly.

4.Position of the base of lift around or under the object.

5.Widen the base.

Fitting Lumex Sit-to-Stand Sling

Warning: The Lumex Sit-to-Stand sling is not suitable for patients who have involuntary movements, or patients with limited postural control.

1.Position the patient in a sitting position.

2.Slide the sling down patient’s back to lumbar position.

3.Draw the shoulder straps to the front of the patient close to the chest.

4.Draw the waist belt around patient’s waist and press together to fasten.

5.Place shoulder straps inside of positioning loop.

6.Attach the shoulder straps to the hooks.

LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual