Braun VL955 manual Fully-Folded Roll Stop Up-vertical

Pre-Lift Operation Notes and Details

Fully-Folded Roll Stop (Up-vertical)

Activation

Feet

Fully-Unfolded Roll Stop (Ramp position)

Automatic Outboard Roll Stop: The outboard roll stop provides a ramp for wheelchair loading and unloading at ground level (see photos at left). When the platform lowers fully to ground level, the roll stop activation feet automatically unfold (rotate) the roll stop down to the ramp position (fully unfolded). The two activation feet (one at both ends of the roll stop) ensure roll stop operation on an uneven surface.

The roll stop is spring-loaded to automatically fold (rotate) to the vertical position when the UP switch is pressed. As the activation feet lift off the ground, the torsion springs rotate the roll stop to the vertical position.

Note: The platform raises

approximately two inches before the roll stop reaches the fully UP position. Discontinue lift opera- tion immediately if the roll stop does not operate properly.

Outboard Roll Stop Operation: The lift operator must press the DOWN switch to lower the platform fully to the ground. The lift operator or attendant must view the platform as it lowers to be certain the entire platform reaches and rests safely on the ground (see photo on page 16). Stop pressing the DOWN switch if any portion of the platform is obstructed while descending or the entire platform does not reach ground level for any reason (contact with an obstruction, mechanical failure, exceeding the lift “floor-to-ground” capacity, etc.).

Page 15